2 Pack UCP202-10 Pillow Block Bearing - 5/8" Mounted Pillow Block Bearings Solid Cast Iron Base - Self Alignment

Item as described. Really well made. One was a little tighter then the other and did not rotate as freely but for my application it was fine. It does have grease fitting so it can stay lubricated after many hours of use. Operated smoothly and with out issue or defect. Bolt location was uniform and easily mounted to my structure.

These worked perfectly for the auger jackshaft system I built for my bin. They're super easy to use since they self align, run smoothly, and seem like great quality. Great value for the money and I wouldn't hesitate to buy them again.

My husband’s very happy and pleased with this product. Well made . Would recommend

I picked these up to use for my steering on my Baja Bug build. When I was looking at the measurements in th head I was a bit worried they would be too big to use. As it turns out they are perfect and WAY better than what you find on the off road websites. These are not flimsy and cheap. They are robust and built very well and will most likely out live the Baja. I am very impressed with them, the fact that they have zert fitting's is fantastic as I can lube them up after playing out in the desert. The price is amazing as these are well worth more.

Parts came quickly, look good

as descibed. worked perfectly.

Nice bearings should last a long time

By all appearances this should be a solid product. Pretty simple technically. But I had two issues with it. First, when the bearing was being pressed into the housing, a small round metal ball got stuck between the two. This caused the bearing to be installed incorrectly, which would have caused operational issues. I tried to use a press to remove the bearing, but it was permanently stuck/welded. The bottom line - this should not have happened and is a quality issue, but I able to fix it with a press. Not everyone has a press, though. Second, there is limited clearance to you to insert an Allen wrench and tighten the set screws, as the housing sticks out a bit too far. I ground a small notch in the housing to provide the needed clearance. The bottom line - this would be an easy design fix.

Totally useless item and waste of time for me. Inaccurate bore measurement. The bore is actually 1.17" (not 1.25" or 1-1/4" as described) This now means the shaft has to be machined either at both ends which will cause assembly issues or machine the entire length of shaft which will cause inaccurate specs and with added cost. Returning item for refund.

pour essieux de petits remorque

Gratamente sorprendido, mejor de lo que esperaba por compacto, eficiente, fuerte y funcional; muy satisfecho