EWORK Bench Dog Clamp 3/4" (19mm) Up to 155 Lbs Clamping Force, Quick Clamping and Release Design for Workbench & DIY (2 Pack)

This is a must for woodworking. It makes working with small pieces of wood so much easier. It holds the piece of wood tightly to the work bench while you route or sand without the clamps being in the way. I love it!

These are an awesome set to own

One thing quickly learned with woodwork is that there are usually a hundred ways to do the same thing. These clamps fit in bench dogholes and allow you to stop work pieces sliding around when you cut, screw, hammer, bleed etc. One half acts as the stop, the other pushes the work against it. Are there other versions and other ways and other designs to do the same thing - of course. But these work pretty well.

These are great to have for woodworking, preventing pieces of wood from moving. Fits exaclty right in a 3/4 hold, no wiggling or play. Good adjustable length and the locking mechanism is strong and sturdy. Durable plastic and yellow color is nice and easy to find in a messy shop :). A little bit pricey but well worth it compare to other similar clamps i had that would not hold up.

These dog clamps fit my Worx Pegasus table just fine. Not sure why other people had an issue with their Pegasus table. For my needs, I don't even need to attach the black knobs to the bottom of the table. The clamping force keeps them in place just fine. Probably best not to even attach the knobs if you're going to store the table, since several of the dog hole locations will prevent the proper closure of the table with the knobs attached (note - clamps won't stay in place either (not a tight fit to table). Update: The upper parts of these clamps fit my Worx Pegasus table but the lower parts (securing knobs) do not fit at many of the dog hole locations on this worktable. These securing knobs are well made and as such probably make up a significant amount of the overall clamp cost. To not be usable at every dog hole of the Worx table doesn't make these a great value. I still like the visible parts of the clamps though and they work well. Would love to be able to buy the upper parts by themselves.

Great value for the money. I have a home built MFT table with 20mm holes, these work perfectly. I tend not to use the threaded knobs underneath for holding the clamps - they work fine without them. When I need a little extra holding power or on my vertical MFT little table, then I use them. Lots of force, and then do hold with a lot of pressure. Great for holding parts to plane or sand. I bought the 2 pack to try - will now get the 4 pack.

The EWORK bench dog clamps are easy to work with. I purchased the 3/4" size because that's the way my bench is set up for and my portable DeWalt work bench is set up for. They went into the holes nicely and with the bolts that came with the clamps makes it easy to attach it to my workbench. On lighter projects I don't even attack them to the bench, sometimes I won't use them as clamps, I ll just use them for stops to keep my wood from moving. The price was good and they have held up nicely.

Decently sturdy for smaller projects. I like that the clamp engages a bit further closed to enhance the grip. Unfortunately, one clamp arrived broken with the grips snapped off.