Bands for Moonswatch Watch,Curved No Gap Rubber Strap Compatible with Omega X Swatch Moonswatch Speedmaster/Rolex/SEIKO 20mm Watch,Swatch Omega Moonswatch Speedmaster Watch Replacement Band Men Women

Purchased for my 30+ year old Citizen eco-drive diving watch. Looks great and has held up really well over the past year or so. I have smaller wrists, and this watch band fits perfectly. Most other diving watch bands are way too long for me. They are also probably designed to go over a wetsuit. I think I read that other buyers had difficulty installing the band. I've replaced bands on many watches and this one probably took me as long or longer than any other watch. It probably took me 10 minutes to finally get the pins compressed and aligned with the holes on the watch. A very tight fit! Once it is in, however, it feels very secure and is quite comfortable.

Nice fit

Nice strap with a clean, no-gap fit that looks great on the Moonswatch. The rubber is comfortable, flexible, and feels durable for everyday wear. Easy to install and a big upgrade over the original strap.

I bought this to replace the cheap looking nylon band that came with my titanium Berny watch. Although a little stiff at first, the TPU/rubber that it's made of is better than the sticky silicone bands that you find everywhere. The curved end, no gap feature is the best. This gives it custom made look. Beware, it is made for slim wrists as it is a bit on the short side.

Great feel, good quality and easy to replace

Does not fit the omega swatch properly. There is a gap on the back and the seller makes it a pain to return.

While this band fit my watch perfectly, I don't like the stiffness of the rubber material that they use. It is a quality band, but I really like my silicone rubber bands better.

Was concerned, and very happy when delivered. The band curves perfectly tight around my watch, and the thickness matches my jubilee bracelet/band. Looks and feels like I expect the expensive online rubber bands do. The buckle and thin gold side strips is a decent color match to my 18ct gold bezel. The thin gold lines are inset, so prevent from being scratched off. I’m not sure how the buckle will hold up to scratches, but it’s been on my wrist 24/7 for almost a week and no issue thus far. Getting it on is tricky, but the tool provided works nicely. One end of the tool is designed to pull back the spring loaded tip and release into place. I was able to do it in my car within 15 min. You want to feed the band up through the watch sides (back to front), with the tail falling down almost vertically. When the pins in, then rotate the band up to fit into place. Do not try to match the rubber band to the watch before the pins are into place.