11 PIECE BEARING AND SEAL DRIVER SET IN CASE

This kit takes a lot of the worry and stress out of removing and installing seals. The aluminium is nice and less likely to cause damage (though I'm not certain it would survive well against a stuck bearing).

Fitted the wheel bearings on my aprilia really well I didn’t use the drift to hammer them in though I got a length of M12 threaded rod a film of oil on the bearings and pulled them in by tightening the threaded bar. Worked a treat

Allowed me to install bearings into a pair of motorbike wheels for the same price as I'd have probably been charged at the local dealer. No doubt it will see action again in the future. Lots of sizes and each disc can be used either way round to give even more size options

Well made and nicely machined, with a handy storage case. Made knocking the engine and gearbox bearings out of a vintage Triumph motorcycle engine case the work of minutes. Used a little bit of heat around the bearing, a few sharp taps with this tool, and they came out with no damage and little effort.

This item was quite surprising and tough trying to get a van bearing to move after 10 years of abuse is a great testimony to it good little bit of kit

Worked well and was at a reasonalle price and good quality for a diy motorcycle tinkerer.

Well made and done the job. This is being used with a 10 ton press and has worked well on all tasks so far such as pressing in/out bearings. Does what it should. Seems as though it will last.

Good set - helped me to change a wheel bearing PT Cruiser. The only down side is that if you use it with a hole that is a bit smaller it will chip on the sides. Other than that - works all right.

Parfait

Utilissimo per lo montaggio dei cuscinetti ( l'ho usato per quelli della vespa). Materiale robusto e di buona qualità. Pratica la confezione