Rubber Grip Glove Sleeve Insert Fits Full Size Commander & Government Model 1911-2 Pack Black

I put these on my 1911, and immediately noticed an improvement in how the gun 'felt' in my hand. When I'm shooting, it just feels 'right', I'm not thinking about my grip, I don't notice the recoil (10mm), and 8" steel target at 50 yards is an easy shot (iron sights) I warmed the grip with a heat gun (to make it more pliable) during installation. Installation was simple, with minimal trimming to achieve a perfect fit. I've recommended it to multiple friends/relatives with 1911's.

Feels nice on the finger for grip

put it on a 1911, easy to install, fit well, comfortable to the hand, feels sturdy. Recommended. Just remember not to over tighten your grip screws!!!

It fits but I wish the front part of the grip went up higher. It's too low snd the rough part of the metal stapling still gets you on you middle finger

Perfect fit for my 1911

Not bad it took a little time to wrestle the grip into place but it seems to be working well

Install these under your classic grips for improved handling and ergonomics. They’re inexpensive, rugged, and allow you to keep whatever aesthetic you want for your grips without making them oversized or cumbersome.

These are the perfect compliment to any 1911. I had to trim it down a bit for my officer sized bob cut 10mm 1911 but that was simple enough.

Made airsoft look movie like.