Wahoo Mount, Out Front Combo Bike Mount for Wahoo Elemnt,Wahoo Elemnt Bolt, Wahoo Elemnt Mini, and Camera (Adjustable Wahoo Mount)

So I bought this because the wahoo mount that i got with my bolt was not sat right (because of the shape of my handlebars)which made it look very off centre.So i took a punt with this mount,It seams very sturdy indeed ,it’s adjustable which is great as you can angle the wahoo to your desired position.Also i know this is a ‘combi’ mount for gopro etc but I wasn’t interested in that so i removed the mount underneath which makes it looks aesthetically better.I haven’t taken this out for a ride yet so As long as it doesn’t snap in half while on a ride i will be over the moon with this purchase!!

First off, the unit itself arrived with some minor chips and compression marks. Enough that I initially thought I had gotten a second hand unit, but it just looks like somewhere up the chain it was in box with something else and picked up these marks. They are mostly cosmetic.The actual usability flaws start quick however.The mount is close to the Wahoo mount, but not quite it. There is constant pressure throughout the turn, enough that I'm slightly worried it might damage the gps. At the end, the gps has rotated beyond the straight position and it never clicks into place like other mounts despite there being tabs for it.The arm is held in place by two screws. Normally this would be fine except that the screws and the contact points between the arm and the mount that attaches to the stem are completely flat. So you are relying solely on pressure between the two parts, and since they don't fit together perfectly, the arm can move a little.I'd recommend putting some electrical tape in between to help the piece grip each other. I can no longer move it by hand after doing so but we will have to see how it works after a pot hole.For piece that attaches to the stem, the bolts just slightly fit in the inset and actually bind slightly. This means any attempt at torqueing the bolts back in place is not going to work.

I have bought two of these - the first one I had to file down a little bit to fit my stem (extender bars too short to fit to bottom 2x stems). I bought another to try on a different bike but same issue - this time can’t improve it by filing unfortunately. If anyone has found slightly longer (2-3mm) longer extender bars/spacers I’d really appreciate a heads up as this is the only flaw of this product. Have searched high and low for spacers but have struggled to locate….. the ability to adjust the angle of the cycling computer is key attribute to this mount

I have a Wahoo ELEMNT and a DJI Osmo Action, so this mount seemed a perfect option for me. It's a great mount, very solid with the Wahoo lifted slightly higher on the handle bars than my previous mount and the action camera tucked away underneath.The only real downside is the camera is then upside down (not really an issue though) and that it's a little harder to operate the camera and also check it's working and framed well.That's not why I dropped the start though, you should be aware of those when buying. What I didn't expect was how hard it would be to get my DJI mount to slide into the slots on this mount. The gaps must be slightly too thin, to the point I was beginning to think it wasn't compatible! Eventually I got it fitted. It was just as hard removing it this morning. I'm not looking forward to fitting it back on!Still, all round a very good double mount. Would buy again if I got another bike.

The mount is very useful and well-made but I must admit it's VERY difficult to insert the gopro case / gopro itself in the mount.I used to have a similar one with fixed angle and it was so much easier to use...

Decent product, not particularly light, extender tubes too short to fit Ritchie stem. Needs some slight modification, not on bike yet.😕

Sturdy product. Screws where M5 so had to drill out for the M6 bolts on my stem. Still strong.