ASROCK MB B365 PRO4 LGA1151/ Intel B365/ DDR4/ Quad CrossFireX/ SATA3&USB3.1/ M.2/ A&GbE/ ATX Motherboard

Pros: The board looks nice even though it does not have any over-the-too design with RGB. Everything fit easily. 3 fan headers for chassis fans so you should be good for most of your fans. It has many port on the rear including USB-C. There is a right angle SATA cable and normal SATA cable that is provided. The Manual was helpful. I did not have any problem yet and it has been able to accommodate all the hardware put on it.Cons: Installing the M.2 SSD (SATA 128GB) was a bit confusing because apparently you have to use the heatsink screw to hold the M.2 SSD in place. Putting in my RAM which was 2xT-Force 8GB sticks was pretty hard. I switched on my computer realized it wasn’t turning on and noticed that the RAM sticks came out of place. Seating them took more pressure than many people would be comfortable with but I got it to wiggle in. The board is a bit heavy for its looks. Even though this motherboard has a USB-C port on the rear, it does not have a USB-C port for front panel connector which isn’t a big problem for most people.Overall: I paired this motherboard with an i5-9400f and did not need a BIOS update since almost all B365 motherboards comes with a BIOS update. I installed a dual fan 1660 super and the motherboards steel armor PCIe x16 slot holds it easily without sagging. So, I am pretty sure it can hold a triple fan without problem.I think this is a great motherboard one that has an LGA1151 socket and it is definitely something you can use for your first build. The BIOS is EXTREMELY easy to use. If I was able to navigate through it, you probably can. If you are going with 8th/9th gen Intel i3 or i5 (you can use K CPUs such as i5-9600k but it’s not recommended) then this motherboard will suit your build very well considering the price. If you are getting a 8th/9th gen Intel i9 or i7 then I would recommend paying that 30-60$ extra to get a Z390 board instead of a B365.

The media could not be loaded. So this is for my “guest” gaming computer. It only gets used maybe once a week. Have not had any problems running any game we throw at it. It is a base motherboard. Understand that if you get it. It is a no frills MB but it works. Looking for a cheap build go ahead. No complaints with the install.

The first purchase was two of these boards to use in a dual PC situation, but I found out the boards were susceptible to power outage damage (rapid power cycling); this is not the board's fault, so I managed to save on of the PCs, and then I purchased a new board to build a new system, which I will put on a UPS after I deploy it. Lesson learned: always run your PCs from a UPS. Good Motherboard.

ASROCK MB B365 PRO4Pros:- Easy install- Looks good- Working great so far- Good bang for your buck- Good Intel budget board- Supports 8th/9th Gen! (Currently paired w/ i5-9400F)Cons:- Manual not that helpful- IO plate/shield looks and feels a bit flimsy but works fine- Some pins would not hold cables so make sure to check/push down before turning PC on- QVL not updated (Current SSD/Ram not on QVL but work fine*)*Samsung Evo 860 500GB 2.5 In. / Corsair Vengeance LPX 2x8GB DDR4 3000MHz C15

I'm not well versed in computer hardware but this make computer work good. This and the processor were pretty easy to install overall, although we did have a bit of trouble with the funky little plastic screw things to hold the processor in place. Very stressful, but everything else went super smooth.

Finally got around to installing it yesterday because I was in the middle of moving. It ran for half a day and then got about an hour of Valorant out of it before it died. I assumed it was the power supply so I ran out to to the local computer store and bought one this morning. Came home and put it back together. Motherboard will not power on at all. Seller will not take it back and neither will amazon. Now I have to do an RMA that will take weeks. This is a complete disappointment. I have built a dozen or so computers over the last 20 years and am a year from a CS degree so I am fairly well versed in computer building. I have never had a motherboard die so quickly. Every single entity involved immediately renounced all responsibility for this little piece of trash. Even ASROCK kept trying to get me to have the seller or amazon replace it because they don't want to have to deal with the garbage they sell. Would not buy again. They call themselves asrock because it works as well as a rock.

There are plenty of plugs for case fans, and ASROCK includes good BIOS features with their boards this one has six SATA connectors so you can make a hardware RAID. The MB has two 4 pin connectors if you plan to overclock the your CPU. It supports 8th and 9th gen 8 processors; but not the 10th, the i5 9400 is what I wanted and it runs circles around my i5 4590 in my old pc.I payed too much for this motherboard, it was less than $120; but four days after I purchased it Amazon dropped the price, that was before it was shipped but do you think they gave me a price break, No!

Not bad hardware for the price, plenty of data and m.2 ports and a WiFi 6 port as well,