Amazon Basics Coffee Table with Drawer, Rectangular, Waxed Solid Pine Wood, Traditional, Rustic, 56 x 94 x 45

We really like these tables. They are sturdy and they match our other furniture. Very easy to put together.

Very nice tables.The pine is very dense. It would have been much easier to assemble if pilot holes were pre-drilled, not the end of the world however.You'll need strong forearms, a good screwdriver and some protein powder – I would also recommend warming up your forearms and doing some stretches in preparation for the job... or alternatively; a power drill with a long 2mm bit will make the job much easier.The included screws are rather soft, make sure you use the correct size screwdriver or you’ll end up ruining the head. Would have been nice if they had included better quality screws, or even better torx head screws.I was about to rate this item 4 stars due to the lack of pilot holes and poor quality screws – but have decided to rate 5 stars due to the low low price!

Assembly wasn’t too difficult at all and product looks great for what it costs. Tables are all level and feel sturdy enough. Only problems were one of the underside pieces was cracked as shown so the dowels were pretty loose and I didn’t want to drive the screw in as much and risk breaking it completely, but it still went together fine. The black metal circular trim pieces need hammered in and can be tricky, if you hammer them too hard and not perfectly straight they can bend, so it takes a bit of care

Stylish and easy to put together!

OK, so they're cheap, £35. Even so, for flat pack, you expect the assembly holes to be drilled correctly. Assembling these tables was a fricking nightmare.We found that where the screws were to go in was splitting the wood, so our task no.1 was to drill our own pilot holes for the screws. Secondly we noticed some of the holes where the dowls should go were not drilled at all. So, we had to drill our own dowl holes, measuring carefully, and even then, I got it slightly out. I couldn't re-drill, the hole was too close, so that fastening wasn't used. Thirdly some of the holes that had been drilled for dowls, weren't in the right place.In the factory, don't they have machines which you can programme to put the holes in the right place on each piece, not massively out of place? And lastly there was 1 screw short when I unpacked and counted. I had to match it up with 1 I had from my tool box.So, we've put 2 out of the 3 tables together, but we've left out so many dowls and screws, I don't think they'll stay in one piece for long. We're going to Ikea to replace them.

Good priced tables,need good waxing,sturdy.Good service.Recommended.

The tables look great, the wood is good quality. The only downside is the quality of the screws, they snap, the head becomes blunt and because of this I have half a screw stuck in one of the holes that can't be retrieved. I've had to superglue that particular area together as there's no other way to hold it together. I used different screws for the rest and had no further issues assembling the tables. They're a lovely colour and size. I'd buy again but would recommend anyone purchasing this to invest in some stronger screws

Its awesome I found it a bit difficult to assemble but finally done it