TIG Welding Cable Panel Connector Socket EDKL10-25 200A 2pcs

These quick connectors are great for welding wire. It let's you easily connect and disconnect the leads so they can be stored easily. The connections are sturdy and make excellent electrical connections.

Excellent quality

1 of them cracked when torqueing the set crew but I probably over did it

Works and fits well. I was able to install on #2cable.

Needed to make extensions for welder leads for a 225 amp stick welder. These were the same size as the panel plug on my Harbor Freight welder (100 - 200 Amp connector - Harbor Freight doesn't overbuild anything). Worked perfectly with 4AWG cable and were very easy to assemble. The rubber boots are keyed, and the keys are marked on the face. I assembled the male ends first, then the female ends so did not mix up the rubber boots, as they are different.The sleeves allowed me to use cables with exposed and mashed ends with very little effort - without the sleeves I would have had to cut off the mashed end and cut back the insulation to get the four gauge cable into the socket. Took a matter of minutes to assemble. Very pleased.

Good value. Solves making the ground cable longer than the 16 foot plasma torch. The stock ground cable is 7 foot. Worked perfectly for making an extension cord for my CUT50 plasma cutter. Assembled the ground cable using Dielectric grease to prevent corrosion over time.On the male end of one connector the rubber cover would not lock in position so I used some Loctite poly seal to retain it. This stuff goes on white and dries clear. It is an excellent sealant and bonding agent.Black Electric Tape was added to seal up the cable to the covers.

These adapters fit better than the ones that came with the machine. good buy

Bought these to add a 1500W inverter on my 06 Prius. I wanted the inverter to be able to quick disconnect that way I can move when not in use.They worked well, the only problem with the product was the crush pins to hold the wires just fell out after being crushed, it worked just fine with just screwing the tap screw straight onto the wire.The only other thing that didn’t work well for me was it doesn’t have a cover so if you disconnect it but still have juice on it you basically have a tiny pair of bad jumper cables.