Stage 1 Boost Cooler™ Forced Induction Water-Methanol Injection Kit (Red High Temp Nylon Tubing, Quick-Connect Fittings)

It works well, I have been using this product for about five years now and still works great. The only complaint I have is that the water nozzle corrodes from the inside out even though is made out of stainless steel. Another thing I don’t like is the availability of different nozzles if required.

This is a good starter kit to run on a stock truck but will need another large nozzle if you are running much more hp over stock. The tank is small and would work for short bursts of cooling but if you are planning on using this on a tow rig then you should look at a bigger tank

Like that it comes on with boost pressures, would like to slit injection and put a little of water, in front of turbo

So far so good. Used on a 6BT, works great. The boost switch is setup at 10PSI so I empty the first gallon very fast, I had to re-adjust the boost higher to avoid this.

only gripe is that they don't put the actual product in an unmarked box. so the thing was just sitting in my front porch with the item label BOOST COOLER METH KIT in big letters on the front so it gives thieves an idea of what they're shopping for when there walking around . but that's not anything im going to doc a star for. so five out of five for me

Install is very easy. This worked great for my small turbo diesel as it’s always in boost, so this is a better match for the engine than the stage 2 or 3. The kit comes with a #3 & #5 nozzle. The #3 nozzle works great, I get a bunch of power but use a ton of meth/water. Ended up buying the #2 nozzle and it’s a better match for my engine. Space is very limited in my vehicle so this worked as an alternative to an intercooler. I added an arm/disarm button so I can deactivate the system when I don’t want it on at all. The boost switch went bad 3 days after install, Snow replaced it no questions asked. It has been working flawlessly since.

Water injection to help 1995 6 cyl Jeep pass California smog! Solved a “no pass” problem.

I received my kit the box seemed like it was a display. Beat up on inside ripped an torn. The kit didn't come with the fittings for the pump and 90° elbow and the fitting for the bottom of the tank resivor. Looks nice but worthless if not all there. Spending that kind of money and part not there to install awaiting response from PStuning. (Revised) PS tuning did great on helping me get all of the parts that wasn't in box. Took a long time but now I'm ready to install. Ty ps tuning.