PHOLSY 6.5' / 2 m E-TTL Off Camera Flash Speedlite Sync Cord Hot Shoe Cord Compatible with Canon T8i, T7i, T6, T6i, T6s, T5, T5i, SL3, 90D, 80D, 77D, 70D, 7D, 6D, 5D, M3, M5, M6 etc, Replaces OC-E3

Works with all my E-series 4/3rds Olympus DSLR's (haven't tested with Micro 4/3rds) at a fraction of the cost of the Olympus model. Cord is heavy duty which can be a challenge to work with at times but a fair trade-off as it will hold up under frequent use.

Good cord, perfect length. Really handy for street photography

I'm sure there is a reason why someone would need 2 meters between their hot shoe and flash, but I do not. This item does exactly what it is meant to do and is of very nice quality, but the extra length is a bit of a challenge. The locking lever on the hot shoe end is very nice, but it would be nice if it could mount with the cord running the opposite direction.

I found this particularly helpful during an outdoor product photography shoot where having a large light setup wasn't possible. My assistant was able to easily hold the off camera strobe at the product setup to fill in shadows. The cable is sturdy and the coil stretchy enough to allow enough distance from camera without having to 'pull'. It also helped me keep track of my strobe in all the chaos. I would love to have a longer cable and will see if they offer one as in studio you do need your strobe setup and tripod setup relatively close due to the coil of the cable

So far I have just done a few tests, but it works as expected and is just what I needed to move the flash away from the top of the camera. It seemed a bit strange that the cord pointed forward on the hotshoe mount, but I found that this is necessary if you want to use the camera hand held and be able to use the viewfinder. It may be necessary to weigh down the light stand with the flaslight with a sandbag because even if it is a spiral cord between the camera and the flash it is a bit stiff, and could cause the stand to tilt and fall over if stretched.

Pholsy does a good job of providing off camera flash. For that I would have given it a 5. However the on camera hot shoe connector has a solid plate contact with the camera. Therefore it cannot pass connection to non-flash accessories. Thus, my gps sensor, which connects to the hot shoe will not work when I have the Pholsy connected! Therefore, I rated this a 3 for poor design.

Flash cord works but the design attaching to the hot shoe of the camera makes this unusable. Cord design comes out straight to the front of the camera and the heavy cord falls in front of the lens. This makes it unmanageable and unusable for my work.

I was surprised how heavy duty the device and cord is. IF I had a complaint, and it is minor, I wish the cord was a bit shorter because of the quality it is a bit heavy. But don't let that stop you from buying this.