0-48V 0-12.5A 600W

I had been using this power supply to charge batteries and it died charging a LiPO4 battery. The seller provided so fix suggestions and when they didn't work they provided a replacement unit that has been going strong. I'd highly recommend as this power supply because can charge just about anything

This power supply works fantastic and seems very well built.

Disappointed in this product. The pictures are misleading or the power supply doesn't work properly. You can adjust the voltage and I metered it so all good there but not the currant (amps). The amperage display only shows the draw. The dial does nothing. I tried the current dial with powering up a device and without and again it does nothing. I have a test power supply that lets me set a precise voltage and amperage but only goes from 0-2 amps and 0-30 volts so I was hoping this was about the same but higher voltage and amps. Debating on returning this since it does not do what it says it should.

Does the job for low voltage nickle plating use.

Great product ! Thanks

This thing works very well, goes into current mode and voltage mode as expected, and the fan only turns on as needed under high load. I use it on my RV to feed in parallel with my solar panels into my solar charge controller, when connected to shore power. The back-feeding of the solar array into this power supply when unpowered turns on the green LED on the supply, so I'll probably install an ideal diode soon to stop that small amount of waste when running in solar mode. The MPPT charge controller complains that it can't target the max power point when this supply feeds it (because it's not a solar array), but it still charges the battery at max current, so whatever, still works great.

I'm using this power supply in lieu of the one that came with my 600w 48VDC brushless spindle motor on my cnc. I love that it has 2 controls, one for voltage out, the other for amperage. The fan, which is almost silent, is thermostatically controlled.I use the voltage potentiometer to control the rpm's on the spindle motor. The power supply is very stable. When I adjust it, it stays at the voltage chosen. This translates into a very stable supply for the spindle motor. When I set the voltage to the rpm's that I want, the voltage is stable therefore the rpm's are stable and consistent.This translates into incredibly accurate cnc cuts. The "R"s in the picture I'd about 3/8" high.

Works but the pots are very touchy and the display isn't very accurate. Couldn't get the amps and volts to act independently of each other partly due to load. Will probably have to get the slightly better ones since I want to use it for float charging batteries.