Photon MONO M5s 3D Printer Screen Protector,Original Protective Film 5Pcs for 10.1 inch LCD SLA UV Resin 3D Printer-Thickness 0.1mm-ONLY for Photon MONO M5s&M5s Pro NOT for Photon MONO M5

Fitment is perfect...quality is top teir...best bang for the buck. Adhere to screen with no issues.

These fit my Anycubic Photon Mono M5 very well, and even when a cheap FEP film leaks a couple drops of resin on these protectors, you can usually soak the spot in rubbing alcohol and use a plastic scraper to save it, so these don't scratch very easily. You'll get bubbles probably but minor bubbles don't seem to negatively affect the prints.

The only screen protectors I'll use on all 3 of my Anycubic Photon M3 Printers. My only issue with Anycubic is they can't seem to keep their products in stock enough to meet demand. I run a 3D printing business and I've had to close down for over a week before from not being able to find Anycubic products in stock anywhere here on Amazon or on their company site. For this reason, we've slowly began replacing our 3D printers with another popular brand that seems to keep their products in stock everywhere.

Works well to protect the screen, especially for the cost to get 5 of them. They fit fine, however installation is about as easy as installing a phone screen protector...but on a 10" screen.

And doesn’t come with any tape/adhesive covering for the gap between glass and base like the OEM protection does. You’ll need to find some thin tape to cover that gap to prevent any leak or drips from making its way into the electronics below. This protector is NOT like good quality cell phone screen protectors that let you easily squeegee out bubbles. This requires far too much pressure to be safe. Be careful to slowly apply the sheet and gently press along the line as it adheres to keep bubbles out. Other than that, it applies easily, has nice clarity, and results in good prints.

Well, their new size 10.1-inch protective sheet DOES NOT FIT the Anycubic Photon Mono M7. I was leery when I pulled it out of the box and when I installed it, lining it up from top to bottom, there's a 1/4 exposed gap on the bottom portion of the screen. Now I'm going have to order the 13.6-inch film.

Works great. Do not print without it!

Great buy. Great film and has the gaskets included. Hard to get the bubbles out, but that's the nature of any of this stuff. Will be purchasing more. Just a warning. It's okay to purchase this aftermarket LCD protector for the Anycubic Mono 4k, but I DO NOT recommend using the aftermarket FEP film for the resin vat. Purchase the ready made FEP already mounted to the metal plate bracket made by the manufacturer. It's more expensive but you'll regret it if you don't

フレームが壊れると使用が難しいので生産終了前に数枚買っといた方が無難。 スクリーンの方は何とでもなりますが。

A deja sauver mon imprimante plusieurs fois , un indispensable, et en plus facile a mettre

Rien à dire

Excellent produit

Perfetta e intercambiabile.