EZ Flares XL - Fender Flares PRO – Original EZ Lip Offroad Universal Flexible Foam Rubber 2-Inch Fender Extension

Very happy with the EZ Flares, so far it’s been a little more than 2 months since I installed it and still see no signs of it falling off. Installation was easy. I made sure the surface was clean and heated it before sticking it on. I did make some holes on the ez flares to allow access to the fender pins and so that the pins can hold it just in case. It’s seen some off-road action and plenty of rain. I live on a road with plenty of mud and rocks, It helps to prevent rocks from scratching the paint and mud from flying. I’m also happy with how professional it looks and have these installed on the front fenders of my Vehicle.

Barely sticky. Would not hold at all.

A few inspection places whined about my wheels sticking out 1.5"-2" from my fenders. But I don't want to drill, rivet or screw stuff into my fenders. That's where these awesome fender flares come in to appease the man...These look pretty decent and confused people. They look like mat black plastic material until you find out it's foam rubber.

Installed on my wife’s Jeep Wrangler JLU after replacing stock tire and wheels. Very easy to install and was surprisingly impressed with how it looks. The material is flexible foam with just the right form to look good. Not as good as solid flares but well worth the price paid. We’ll see how long it lasts in the AZ heat. I’ll update review if there is an issue with the lifespan. All in all a solid product for the price.

I took my vehicle in for state inspection (PA.) and they told me my tires were sticking out too far beyond the fenders to pass (even though this same garage had passed the exact same tire and wheel setup at least 3 previous years). I no longer had the stock setup to throw on temporarily, so I started looking for a solution via the internet. I stumbled upon these stick-on flares and thought this might work. I got the 2" size and it was the perfect coverage for my Jeep with 35" tires. I took the vehicle back to the garage, it passed inspection, all is well. I think the flares look great, and I would probably just leave these extensions on. But the adhesive did not do well through the first car wash. There are now gaps where the flares are pulling away from the fender. I followed the installation instructions to the letter and they initially seemed to be really sticking well. There is a method for installing these by removing the plastic rivets along the edge of the fenders, then installing new plastic rivets to hold on the extensions. You can check out the You Tube video for that. That's probably the best solution. Overall I like these extensions, except you do have to buy 2 rolls to cover all 4 fenders. Just know the adhesive will begin to fail after about a month.

Finally got to install this today. Definitely easy to install, and the 3M tape is actually pretty strong. It is important to clean the surface with dish soap and rinse it with warm water. Then use alcohol wipes to clean the surface. Wait a few minutes for the surface to dry and then heat the surface (If you are doing this in a cold weather) with a heat gun or hair dryer. This thing sticks like a glue after it was installed. I did all 4 fenders on my 2018 Chevy Silverado 1500 and I; still have a little left. Yes I had to buy 2 of these to do all 4 fenders and yes they are expensive. I hope they hold up in Maine's cold winter. I will update this review next spring to let you know if they hold up.

Had these on my truck for a month and they are holding up surprisingly well. Used some brakeclean and a rag to wipe down where I wanted to stick it on at and haven’t had a single issue. Had them covered in mud then took it to the car wash and hadn’t found any spot where it’s trying to peel up yet. Description could be a little more specific, they don’t stick out 2 inches from the vehicle but they are 2 inches pointed out at an angle. Like everyone else said, one roll will only do 2 wheels. I’ve since gotten another roll for the front and would buy again for another vehicle.

I order the same fender flares about six months ago and it worked great but I don’t know if I received a front spoiler or what, they are not the same, the first one was more rubber like and stuck straight out, the one I just received angles out like a spoiler, I am not happy with this because I can’t use it, I have put them on my wife and sons cars, the ice rip my old one off that was no big deal just thought I order a new one and it would be fine but I don’t know what I received, have told many people about your product because I got compliments on my Durango but not happy.