Ni-Cd Rechageble Batteries, 1.2V 2200 mAh 4/5Sub C Battery Flat Top Battery with Tabs for Digital Cameras, CD Players Battery Pack (Pack of 12), Green

New and perfect. These Ni-Cad cells fit a B&D rechargable power screwdriver, it uses 5 cells in series. The tabs made most of the soldering easy, 1 cell is off angle, an easy solve. With occasional use they go a month or more between charges. Nice also with exact nicads in a nicad application, I use the same charger.

My trusted rechargeable brand-name hand vacuum's NiCd batteries were giving up after over five years of sporadic use. Couldn't find replacement battery packs, thus I purchased these sub-C NiCd tabbed cells and made my own replacement pack. So far they revived my vacuum to as-new condition. The initial charge cycle took 18 hours (as expected considering the cell capacity and charger current rating). Just make sure you use the original NiCd charger - do not mix these up with NiMH cells or chargers! If you are not afraid of building your own battery pack, these NiCd cells are a perfect solution to fix your older appliances. ( I also ordered 85mm battery pack heat shrink tubing to securely contain and insulate the packs - the blue tubing that you will find under this search term works perfectly for these size cells.)

The batteries are very good, at least so far. I've only had them in my drill for about two weeks. I don't have an electronic spot welder and had to use a simple pencil solder iron. It was very convenient to to have the solder strips already on the batteries. However, when you start lining up the batteries to fit into the case, you will find that the direction the solder strips aren't facing in the needed direction. If you set up the top side of the batteries, the bottoms don't line up to be soldered to the adjacent battery. You end up having to fold the strips somewhat to connect them. I'm getting ready to order some more batteries and I will try to get them without soldering strips. I have already ordered the strips separately for my other battery pack. Also, make sure you have a good soldering iron with a good tip. Do some research on U-tube as to how to tin your tip and make the solder connection on the battery. The other problem I had was they didn't fit height wise. Using an electronic soldering tool keeps the height of the batteries at a minimum. When you solder with an iron, the "drops" of solder build up the height of the battery, top and bottom. You have to be very judicious when doing your soldering. I had to resolder some of my connections to "flatten" the solder. The top of the battery pack doesn't fit exactly on the bottom of the case. But I got it to work. You may decide to simply replace the battery pack .

Used to rebuild the battery pack in an old drill driver. Seems to work as good as or better than new.

They don’t hold a charge very long.

Fixed my Remminton beard trimmer that was 6 years old. Old battery charges and runs 30 seconds and dies. Runs 10 minutes or more like original. Had to solder the tabs but any solder pencil will work, In a pinch you could twist wires and tape. Fixed a $75 trimmer for 8 bucks.

Use these to rebuild my cordless drill battery pack. I've recharged them at least 10 times in the past month and they work perfect. They are as powerful or maybe even more powerful than the day I rebuilt the battery pack.

Will have to see how they last. So far so good

Excelente opinión del servicio y del producto, que me permitió arreglar mi miniaspiradora en forma fácil y competitiva,

Excelente ya vienen con carga así que se pueden usar inmediatamente las use para darle vida a un taladro de 9.6volt

Buena calidad, cumplen su función. Tuve muchas problemas para que llegara a mí pero llegaron.

llego en tiempo y forma, buen producto era lo que esperaba

Lo utilice en una pila de taladro y funcionó muy bien lo recomiendo