JRready ST5253-04 Molex Pin Extractor Kit Mini-Fit Jr. Extraction Molex Micro-Fit 3.0 Terminal Release Tool 3P 4P PC Fan Connector Electrical Pin Removal Tool

Worked as expected, pulled all plugs from two moles in an ev bone to reconfigure a new controller. Tool is rigid and no vents wile using it Worth the price

Bought this set mainly for the Mini-Fit Jr. Extraction tool for ATX and EPS connectors. There are a few of these pin removal tools on the market and a lot of them carry the same poor design; two pieces of flat metal separated by a spacer. I can say from experience while you may be able to get those to work, they are flimsy and hard as heck to use. This Jready set is not flimsy, they have a good holding base, and the tips have an angled edge that helps depress the metal pins when inserting. All in all, best Mini-Fit Jr. Extraction tool I've used in over a decade.

The tools didn’t fully squeeze the terminal flaps, so removal required some wiggling. But it did get the terminals out & I was still able to use the terminals in other connectors/slots

Great quality and value. Bought these after I bought one of the pieces of the set. Works great for the molex connectors. Has all the sizes you need.

I have various other versions of this but for a specific connector, you need one of these that works on both sides of the connector at the same time. Be gentle, and they will work and last. I slightly bent one ear on it, but I was pushing hard.

I purchased some Molex Micro-Fit 3 connectors for my 3d printer hot end. I need to pull the old connectors crimp new connectors and attach a new connector. Step one remove old connections, well this did not happen. This tool is better than some of the cheap tools made of flimsy metal. While the quality is better the double-prong design did not work at all. Very disappointed, and since I pushed and wiggled so much to try and make it work the extractor tool DRK-D120P for female connectors is now bent. After working with JReady they found a tool that works better for my application, the JRready ST5262 Ejector Rod Pin Extractor. They were very helpful and the ST5262 is a great tool.

Bought this to depin molex four pin micro connector 3.0. Works, not much more to say.

I've used these a few times now and they work well. The case for them is not so good however. It does not latch shut, and the hinge is getting close to breaking. Tooks are a yes, the case is a no.

Die passen in die Stecker, aber die Spitzen sind aus Alu? und verbiegen schnell oder können recht schnell brechen, da man doch etwas kräftiger drucken muss, um Kontakte rauszudrücken. Werden sie nicht oft gebraucht oder benutzt sind sie recht nützlos. Für die "Arbeit" eher nicht.