NEWACALOX Magnetic Magnifying Lamp, 3 Color Modes, 10X&5X Magnifying Glass, Flexible Gooseneck, Soldering Helping Hands Base Station

Helped considerably, great product

The magnifier and light work well together. Controls work as advertised. Seems sturdy and stays where you put it as long as the curve is not too tight.

Used to hold props and backgrounds for product photography and it works great. The magnets are very strong, almost too strong.

Pretty good item overall but the reason I cannot give this 5 stars is because the magnet isn't strong enough to hold the unit attached when readjusting the magnifying glass. This isn't a limitation in physics or technology because my other magnetic lamp holds much more firmly to metal surfaces. Other than that, it's a pretty good unit.

built my own helping hands station because i needed a bigger deck than they offer. Love and use this magnifying lamp all the time when working on small electronics and soldering

Wicked awesome for holding hard-to-clamp things together while gluing. A lifesaver for the avid 3D print master! I love how the clamps slide in and out and rotate. That means I can buy custom clamps, get a proper shank and make my own clamps to use with the tentacle arms. Wonderfully though out design! It should be mandatory that all product designers speak to this engineer before submitting their product to production ;)

Great magnifying glass but a very weak magnet I would try something else

Works great at allowing me to see things and the light is excellent.

I use these items for product photography. I purchased two different, but similar products. This set and the ‘KOTTO Third Hand Soldering Tool PCB Holder Four Magnetic Based with Iron Holder, Flexible Metal Arms Helping Hands Crafts Jewelry Hobby Workshop Helping Station Non-Slip Steel Weighted Base.’ I prefer this set. It has stronger arms, the clips are more easily manipulated for fine adjustments and the base is bigger. As a bonus, the two sets of arms are of different lengths which adds versatility.

This little unit has been the best addition to my workbench since I set it up years ago. Saves so my hours and bad solder joints! Highly recommend!

It’s very solid made the only thing I didn’t like about it was the screws that are supposed to hold the clamps in place. The screws do not go through the clamps. If they did it would be awesome cause they keep on getting loose and the clamps start to turn may even fall off. I do micro photography so I use this to set up my shots. Been looking for something to hold up leaves and other stuff for the background of my photos. Other than that it’s solid! 👍🏻

Super stable, good quality electronics station