Clutch And Slave Kit Set compatible with Ranger B2300 B2500 B3000 Bse Xl Xlt Limited Sport Stx Ds 1995-2011 2.3L L4 Gas Dohc 2.5L Gas Sohc L4 3.0L V6 Gas Ovh (Self-Adjusting Clutch Cover; 07-116S)

Excelente

Just installed this clutch yesterday at home. Went in perfectly. Took it out on the freeway and drove it for 30 minutes at normal speed and so far no issues. No unusual noises. So yeah right now I will rate this 5 stars. I will update after I hit the break in period of 500 miles. Then I will try to put more stress on the clutch and see how it’ll do. UPDATE: 500+ miles later truck running / shifting great. No issues. 👍🏼. So what are you waiting for? Buy the damn clutch kit already.

Everything arrived intact and appears to be well made. It fits perfectly in a 1998 Ford Ranger 2.5L. The truck drives well with this clutch kit installed. I highly recommend you replace your flywheel with this kit for the best results. I will update this review after I have put a few thousand miles on this kit.

Very pleased with the clutch kit it was exactly what I needed I will have to say the pre-blade master cylinder setup that came in the kit not sure if I done something wrong in the process but it had air in the system and I had to get a vacuum pump to pump it out but all that being said it works great thank you

1999 Mazda b3000. After spending days working (and not having the Vehicle to drive for over 3 weeks now) to replace the clutch, pressure plate and slave cylinder, the installation stalled when it came time to reconnect the hydraulic line from the master. The fittings wouldn’t couple. I double and triple checked the fingers on the retaining clip in the slave cylinder fitting, but it would not couple with the hydraulic line fitting. I tried ordering a master cylinder in the hopes the new fitting would be compatible with the new slave cylinder, but no, I have to remove the transmission again due to an incorrect part shipping in the clutch kit.

Just replaced my clutch plate in my 98 danger. I was skeptical at first. However Amazon did not let us down. I will continue to use Amazon parts for my daily drivers

I can confirm that this fits a 2002 Ford Ranger XLT 2WD 2.3L 4Cycl. Easier enough to install and my ride has never been smoother. Make sure to clean the pressure plates with brake cleaner to remove the film. Let's see how long it lasts though.

Great quality, its hard to believe you can buy and entire clutch assembly for this price! I’ve put a few hundred miles on it so far, only time will tell! So far so good. Will update if it wears prematurely.

Sa fait maintenant 4 mois qui a été poser sur mon Mazda b3000 2006 et tout va très bien aucun problème jusqu’à présent

Buen producto, construcción sólida y funcionó a la perfección una vez instalada. Recomendada.

Muy contento con este embrague lo recomiendo ampliamente

Looked great as seen in picture

perfect