EPOXY ADHESIVE 8.6OZ MIRACLEBOND

Worked perfectly to adhere door sweep that had come loose from its base (not the door - don't do that).

Used this today to fix some brick faces that spalled off the edge of a brick walkway. Was concerned about the comments of being hard to press from the caulk gun. Used the earlier technique mentioned of not attaching the tube. Easy to dispense without the tube. Squeeze epoxy onto any disposable hard flat surface and easily mix the two ingredients with a flat blade like any other epoxy. The epoxy has a good consistency for applying to surfaces and a good workable time. The tube nozzle has two sides that dispense the ingredients from each side. Pretty smart design pushes out an even mix of each ingredient. Has a split cap insert to re-seal each side of the tube end after use and a screw on top over that to really seal things up. I probably won't have any problems re-using the remainder with the tube properly closed up.

Excellent, performed as advertised. I used this for filling large holes on a vertical surface. I was impressed that it did not sag but stayed in place. It is thick so use a good quality caulk gun.

I used this product to fix my entrance door frame of the basement. It is very easy to use and very strong when dried.

I can't comment on the quality of the adhesive just yet but it arrived without any mixing tip at all. Obviously the tip is necessary to mix and dispense the adhesive as shown and intended. In fact, one picture shows the tip physically attached to the tube. On the tube I received, It was not there and there was no evidence of it ever being attached to the tube. Don't waste your time, choose another product.

Usually you receive 2 nozzles, but it only included one. That means I’m going to waste half of it.

I use bond to fix termite damage and dry rot in Southern California where termites are a protected class by the state govt. But with this product you don't have to mix up bondo and force it into tight cracks. This product is great for filling in all the cracks and crevices in your house once and for all. When combined with my Milwaukee M12 caulk gun, a 4 hour job took 20 mins. No kidding. Buy both and save hours of time

Does what it is supposed to do but is very hard to get through the mix applicator. I bought a caulking gun 26: 1 thrust ratio applicator with 950 pounds of force and it still was hard as heck to get it through. On another job I just squeezed some out onto a surface and mixed it with a putty knife. Worked fine like that. I would still recommend the product.