Pro Marine Clear Table Top Epoxy Resin (16-Ounce Kit) | UV Resistant, Self-Leveling | High Gloss Shine for Wood Table Top, Bar Top, Counter Top, River Table, and Other DIY Resin Art Projects

Es muy poco, los pote son súper pequeños y dejan un montón de burbujitas, no importa que tanto calor le pongas esas burbujas pequeñitas se quedarán allí

I enjoy this resin as a coating resins and for coasters and trays. It's thick so lots of bubbles when casted BUT it isn't meant to use for casting so that's OK. The shipping was horrible. I lost a LOT of the hardener (since it is thin) and some of the resin (as it is far thicker) upon arrival and everything was sticky, the box wet... it was a mess. I lost at least half the product since I need hardener to use and at least 1/4 to 1/3 of the resin itself. To improve the shipping, I would suggest a small rubber stopper that fits into the bottles and prevents leaking. To improve the product I would like to see better UV protection. Especially for a product based off of marine use and one meant for tabletops which are expected to be a longterm piece even if used indoors.. I've been using this in a UV yellowing test and while others are holding up this resin has (disappointingly so) yellowed significantly after 1 week in full sun where as other ( cheaper ) resins have no yellowing at all. The only other improvement I would make on the resin itself is the heat resistance rating. I feel like a table top resin should resist heat to at least 180-200°F. The peak heat resistance for this epoxy after full cure (which takes a couple of months) is a very low 135°F. Anything over this can cause indentations on your project which make this resin less than ideal for coasters, trays, and tabletops the exact things I would like to use this resin on. The low (if any) uv resistance makes this resin less than ideal for large projects you want to last for years (such as tabletops) The pros to this resin is that it cures wonderfully. Great finish, glossy and cures hard. It also releases bubbles well with or without a torch when poured at the recommended 1/8 to 1/4" thickness (again, not meant for castings such as the pyramid used in photos). It also creates beautiful wave effects when used with a good white pigment and produces beautiful blooms within the wave when torched.

Just as ordered

I have tried sooo many resins. And this is one of the best I have used. Sometimes you needs to manipulate others to get it to work and it’s hit or miss with the dimples and such but I can say this resin has not given any issues . No fisheyes or dimples and mixes great. Part a is a bit thick but it melts in and mixes up lovely. The bubbles either go away or can easily be removed with heat gun. There is a little bit of a smell but nothing like some I have tried. It cures in the right amount of time. the work time is reasonable you get a good amount of product for the $. Overall no complaints this is a great resin and cannot recommend enough if searching for resin for tumblers

This epoxy is great for using over wood for tables and things like that. It is not particularly strong for bonding things. Devcon 2 ton works way better for that. This product takes a long time to setup and dry. Depending on what you are doing that could be good or bad. It is not too picky about exact mixing ratio. It combines immediately to make a fairly thick solution which struggles to get down into small cracks like wood knots, wood cracks etc. This does help in not running off areas like thinner products. It seems a good product for what it was designed which is table tops. I thought this was a great deal as far as volume/price. There are better more versatile epoxy products which are more expensive. Just an FYI *no epoxy is crystal clear". Like a varnish they all have some degree of yellow which increases over time. It is simply the nature of epoxy. Most people would need a crystal clear contrast like glass next to it to notice.