Moen 22036 Stainless Composite Sink Accessories

Very happy with this sink stainless it works as intended.

Very good

This is a quality product. M old strainer basket had some rust under the sink and was beginning to very slowly be humid in there...it was really old. So I bought this. I like these cup models because they are easy to install and less likely to have a leak than the other types. I changed it myself and I've never done anything like that, so if I can do it with a youtube video tutorial, you can do it too and save you some $$$ by not having to hire a plumber. It would be hard to screw this up and even if you do, you're losing a small amount of money on trying. Get plumber's putty (about $5 at Home Depot) and with a drill, and a second person to watch that you're centering the ring right, you're good to go. it doesn't take long and should last until you need a new sink or outlive you.

The product met my expectations in appearance and was straightforward to install. However, it lacked an installation manual, which required me to research and watch YouTube videos to ensure proper setup. Once installed, I was very pleased with its appearance, and it has no leaks. If it had come with clear instructions, I would have rated it five stars.

Package came right on time and worked right away. Looking forward to ordering more in the future

Nice, but should have included instructions.

I’ve put a ton of these in over the years. This is by far the easiest and should be the only design for these. Spend the extra couple bucks

There is already a three star review titled "Fine basic sink Strainer but not great", and I will second this opinion. Let's talk about the good: 1. The drain assembly is installed using a cup underneath the sink and a 2 inch nut that can be turned with Channellock pliers, pushing the cup against the rubber gasket/sink, tightening the entire assembly. No special Sink Drain Wrench is needed. This design is also good because the cup does not turn during the tightening and thus does not tend to twist away the gasket under the sink. This makes a good seal. 2. It is an inexpensive drain assembly, with the quality being decent for the price. 3. The drain assembly comes with a second thinner gasket, that you can use instead of the Plumber's Putty. I do NOT recommend using Plumber's Putty under kitchen drains. it can be dissolved (broken down) by water over time. Personally, I put silicone between the drain assembly and the sink, effectively gluing it in. This does not raise the drain in a way a gasket would, and also prevents it from turning later on when the waste pipe is attached or detached. So while this second gasket is of no use for me, you might want to use it. 4. The drain assembly comes with a washer and a nut for attaching the waste pipe. Now let's talk about what's not so great: 1. The above-mentioned review by Music Pro has already talked about the spring clip strainer basket design. Personally, I do not find it being bad. In fact I prefer it to fixed post design of some other drain assemblies, where you turn the strainer basket 90 degrees to fall in the drain assembly to stop the water drainage. This can happen by an accident. With the spring clip design, you at least need to consciously push the strainer to stop the water flow. It is not great though, and I just end up not using the strainer basket in any case. Instead, I put a dollar store basket with many small holes in it. 2. While there is a washer and a nut for the waste pipe, the nut is yellow plated zinc. In my young years, I would use it. These days, I throw zinc nuts away and use brass. Zinc nuts can crack if they make contact with water due to a tiny leakage, resulting in a bigger leakage. 3. This is my personal peeve - you may not care about it - the cross of the stainless steel strainer is located at the bottom of the drain assembly. There is an inch and a quarter deep shaft before the strainer. Why do I need it? If a piece of food gets in there, it will be hard to take out. A better design would move the cross up about an inch. Also, if you wonder what is the difference between model 22036 (this model) and 22037, the later one has a fixed post strainer basket design and under-the-sink gasket only. It is essentially the same otherwise. The total depth of both drain assemblies is two and a half inches.

Looked good but fit was off for me.

La coladera no es muy practica o queda muy abierta o cerrada completamente

- great quality - comes with all the pieces you need - the actual drain piece is much deeper than what i think is standard/normal

This worked exactly as advertised. It was easy to install, and the stainless steel should prevent it rushing out like the previous one did.

Good basic drain. Description should say it's for bar sink. Deeper drain model is for kitchen sink. I still installed on kitchen sink and had no complaint from tenant. Moen has been great with warranty claims on their other products.