VCELINK Cat6 RJ45 Surface Mount Box Shielded 1-Port, Compatible with UTP Cat6/Cat5e/Cat5 Stranded or Solid Network Cables, 5-Pack, White

The VCELINK Cat6 RJ45 Surface Mount Box Shielded 1-Port is well designed and easy to install. I have some WiFi antenna installations outdoors that should be grounded by using shielded Cat6. These surface mount boxes provide a convenient location to tap off the ground in the shielded cable from the antenna. I can confirm that the metal shield housing around the jack is electrically connected to the cable restraint crimp at the other end of box. So it is very convenient for me to add a ground wire to the crimp before crimping and attach the other end of that ground wire to a ground rod in the installed in the dirt. I protect the box itself by tying the box & cables to near the top of a stake, then sliding a piece of 4" PVC pipe with a cap over the upper end of the stake.

I used this as a termination point for two places in my home. It worked perfectly. Very easy to punch down.

These ethernet junction boxes fit the bill when I hard wired the house. They were easy to install, and discreet along the baseboard. Cost of these boxes made the quick project feasible.

I’ve install about six of these so far. Easy to punch down, easy to mount, and they work with no issues. I’m not a sweaty internet benchmarker so I have no clue if there is any network loss of .0000003 or not. Simply put they work for my application .

The base had diagrams for both T-568A and T-568B on a sticker inside. I mistakenly wired it up for T-568A and it failed my testing with a cable tester because the other end was wires as T-568B. I then thought the diagram was wrong. Since the Blue-White and Brown-White pair are in the same positions for both, I inserted those pairs then wire by wire attached single wires to discover the T-568B diagram is correct. It was my mistake using the wrong diagram. The only advice I would give is drill an additional mounting hole in the back piece diagonally from one of the mounting holes on the RJ-45 end, and use it as well as one hole on the RJ-45 end. (Just my opinion)

Great Quality and construction perfect for the job at hand.

Ever time i go to install one of these I'm like what's the pattern, flipped back to the page where i bought it and they clearly got a great image of it. After that it was punch punch and it was installed. Keep up the good work with the photos

These ethernet surface mount boxes are easy to connect to Cat5E and Cat6.

نوعيه ممتازه وسهلة التركيب

Good price/quality ratio. Quick installation. Easy connection, both flex and solid appear to work ok.

Bon produit solide

Easy to install, great value.

Bought these for an interesting project and they worked perfectly. Color label inside to indicate how to wire them and they worked perfectly at 1GB speeds, which is what I was after. Highly recommended.