ECOTRIC Black Engine Guard Crash Bar Protector for 2017 2018 2019 2020 Honda Rebel CMX 300 500 Models

I purchased this for my 2018 Rebel 300 ABS. Flawless install, and took me probably 15min max. I have seen negative reviews due to no instructions so I’ll add some. Will try to edit the review with some pics later. 1. Remove stock bottom bolt with 14mm wrench/socket. Take nut off and remove bolt entirely. (Nothing should move/fall out at all when this is removed.) 2. Insert supplied rod threaded on both ends through the hole. 3. Slide crash bars over new threaded rod (I used the top hole on the crash bar bracket) and at the same time line up the bar in front of rad and guide together. 4. Install supplied locknut on either end of threaded rod and leave loose for fitment to allow everything else to line up easily. 5. Install 2 of supplied half blocks around the frame tube and secure crash bar to frame at crash bar upper bracket location using the supplied allen head bolts (Note one block half is threaded and one is not, one of each is needed per side) and tighten down. Repeat on opposite side. 6. Now go back to the threaded rod at the bottom and tighten down evenly with a 15mm wrench/socket. (A wrench on both ends works best here because clearance is tight for a ratchet and socket.) 7. Lastly install the supplied small set screw in the bar in front of the rad and snug it up with allen key. Hope this helps.

No es posible embonar correctamente en la rebel 500. No trae algunos orificios y llega a chocar con el motor. Me rayo el motor con la tornillería, no lo recomiendo

I mounted these on a 2019 Honda Rebel 300. The installation was easy, only a few bolts per side. It is a glossy black which contrasts with the satin finish of the frame. So, I scuffed up the powder coat and painted it before installing. I think that they look good and seem sturdy enough for this small motorcycle. Also, it gave me a place to mount some pod lights that should help with visibility.

It's a good way to protect your bike, only problem is that the is no instructions. We had to Google it, cause there was something we couldn't figure out.

This crash bar fit perfect on my daughters 350 Honda rebel. Start to finish maybe 30 minutes very simple if you pay attention to where everything goes. Even though there are no instructions it’s not hard to figure out if you’re a little bit handy with tools. Everything went on nice and smooth and so far I’m very happy with it. It looks good on the bike.