Sewer Jetter Kit for Pressure Washer 100FT, Newest 5800PSI Drain Cleaner Hose 1/4 Inch NPT Corner, Rotating and Button Hose Sewer Jetting Nozzle Pearl Corsage Pin Waterproof Tape with 2 Spanner

Used on Stormwater drainage lines at my house. Drain jetter cleaned then flushed (with 2 different heads) worked well to clean silt and sediment from the drain lines. worked well with 6.5hp 3000PSI petrol gurni with 50% pressure on pump and RPM turned up to 100%

طقم تنظيف مواسير بطول 100 قدم يتحمل ضغط حتى 5800 PSI، مع فوهات زاوية ودوران للوصول لأصعب الانسدادات. مناسب مع أغلب أجهزة الضغط العالي، ويجي معه أدوات تثبيت وشريط عازل ضد الماء. ممتاز للمجاري والمواسير الطويلة. أفضل طريقة استخدام: وصل الخرطوم بجهاز الضغط العالي بإحكام ابدأ بضغط منخفض ثم زد تدريجيًا لتفادي تلف المواسير استخدم واقي عين ويدين للسلامة

I'm a professional plumber and have used more than a few jetters, ranging from a diesel-powered 4500 psi "Pipe Hunter" trailer-mounted unit down to a 3500 psi gas-powered MyTana van-mounted system. This jetter kit certainly doesn't compare to those systems, but for emergency drain clearing (or even some preventative maintenance cleaning of your pipes), this system isn't bad. I've used this system at home three times now, once for a clogged sewer line, once to PM my kitchen drain (grease), and once for some roots invading a grey-water line. I'll share these experiences later in this review. First of all, you're going to want a reel with a valve on it. Yes, technically you CAN run this hose without the reel, but it will likely turn into a fair mess of tangled hose in no time flat. I got pretty lucky in that we had an old reel at work that we were just going to trash... those things can get pretty expensive (the one we bought to replace that reel was over $600.00). Secondly, if you've run a professional jetter, you know the hose will pretty-much feed itself. Well, not so much with this setup. This comes down to the tips that are included with this set. They have exceptionally small orifices (this is probably just so that smaller pressure washers can run it). Fortunately it seems that the hose is threaded with NPT (National Pipe Thread), which is the industry standard, so you can find tips just about everywhere with orifice sizes and styles to meet whatever demands you have. Your only limitation will be with the pressure washer that you attach to the hose. Larger orifices need more GPM (gallons per minute) capability. The hose itself seems to be of decent quality, but I've dealt with quite a few jetter hoses (and seen them tear and even burst) and this seems like more of a light-duty hose. If this hose was rubbed against the corner of a pipe a few times I could easily see it peeling. Again, if you're getting this for emergencies or the occasional PM of your lines, it shouldn't be a problem. My experiences: I had a clog in a 3" line, near a combination wye junction that was about 40 feet or so from the cleanout. This was my first time using this jetter kit and I had it attached to my 3300 psi Craftsman pressure washer. I was really expecting the hose to rapidly self-feed (like one of the big professional jetters I've used), but it did not (even using the tip with three rear-facing jets). I had to feed the line in manually. When it reached the clog it did a good job of breaking up the soft material and pushing it through, but I doubt it would have been so successful if the clog had been something more solid (like cloth or large roots). Again, this can be cured by getting tips with larger orifices (if your pressure washer can run them). After that episode I brought home a sewer camera from work and ran it in all my lines (I wanted to know WHY I got the clog in the first place). I found that the 2" drain leading away from my kitchen had a fair amount of grease buildup in it, and a grey water line had some small roots entering it (which is pretty common for buried pipe). I put the rotating head on the jetter and ran it through the kitchen line several times. It actually did a fairly good job of cleaning the pipe of the grease (it wasn't as sparkly-clean as a big jetter would have done, but it was definitely acceptable). Next I ran the same rotating head through the line with the roots. These were quite small roots (toothpick sized at best) and the jetter managed to chew through them pretty well. There were a few stubs still sticking down into the pipe after multiple slow passes, but again it did an acceptable job. Had those roots been any larger, though, I doubt the tips included in this set would have done anything to them. So to summarize, this is definitely a good emergency kit (and good for general line cleaning once or twice per year), but it doesn't compare to a large, professional jetter in terms of capability. I might, in the future, get some larger tips and give them a try, and if I do I'll update this review.

Snaked it first, used my Generac gas power washer to clean it. Easy to connect. I was amazed how well it worked. It pulls in by it’s self thru jets, amazing all 50’ went into the weeping tile. Cleaned it thoroughly. Would recommend to everyone. Great product.

Kinks easily before I've even had chance to use it took an hour to unravel