Chevy front bump stops
Product ID: 310720991
📏Perfect fit
🔧Easy installation
⚙️Durable design
Desertcart purchases this item on your behalf and handles shipping, customs, and support to Spain.
🚗 Elevate Your Ride with Confidence!
This pack of 2 front bump stops is compatible with a variety of Chevy models, including Tahoe, Suburban, and Silverado, ensuring a seamless fit and easy installation. Weighing only 2.12 ounces, these durable bumpers are designed for long-lasting performance, making them an essential upgrade for your vehicle's suspension system.
| Manufacturer | Autoacc |
| Brand | Autoacc |
| Item Weight | 2.12 ounces |
| Product Dimensions | 3 x 3 x 3 inches |
| Country of Origin | China |
| Item model number | 15153958 |
| Manufacturer Part Number | 15153958 |
| OEM Part Number | 15153958 |
| Position | Front |
F**R
Easy to install.
These bump stops were completely missing from my suburban, so it was pretty easy to install new ones. They only make contact under really rough driving conditions, potholes or off road driving etc. so they should last a long time.
J**F
Perfect fit
All good.
T**I
Perfect fir easy install thank you
Perfect fit easy install
B**E
They’re yellow
Bought for my 01 gmc 4x4. Will install soon & update. Update, easy installation, & seem to do the job, although I haven’t hauled anything heavy
M**C
Works on 2007 GMC Canyon 3.7L, 4x4, Z71
It was a major pain getting these inside the holders without the benefit of a lift. Others also indicated they were difficult to install. The Silverado family must have larger holders because these a little too big across the top for the Canyon. But, I couldn't find a replacement part for the 2007 Canyon family so I ordered these anyway after reading where others had installed them on Canyons. After several attempts of working them into the holders with 'flat screwdrivers' I ground the top edge down about 1/8", placed a hose band around it leaving just enough of the stop to start in the holders then squeezed it until the top would fit just inside the holders. I put a 5/8" piece of wood between it and the control arm then jacked the control arm up to hold it in place. I removed the hose clamp and used a flat 'screwdriver' and occasionally a 'helper' to push the top round of the stop past the 3 catch holes' flanges and got it seated with the top fully inside the holders. I've driven about 30 miles on primarily right side up and down patches and pot holes. So far, they're still holding. If someone has an easy way to install these bump stops on a Canyon, please put it out there. These appear as good quality stops. Only time will tell.
R**A
2002 Chevy AV Z66
Perfect fit . It immediately stopped all the squeaks from metal on metal rubbing. The quality overall is 5 stars in my opinion.
E**E
Good fit
They fit nice and snug on my very rusty 1999 Silverado 4WD.Much quieter ride.I cleaned out the rust and hammered the notches back on the receptacle, then hammered the notches back in to retain them tightly.I couldn't rate the durability yet bc its only been a month or two.No issues yet.Cheaper than auto parts store. Most retailers here did not carry them anyway.If they crumble or fall out soon, I will update my review.
L**
2005 Tahoe bump stops
Fit my 2005 Tahoe LT perfect and easy install. Definitely recommend
S**O
perfectos
La medida correcta para una suburban 2002
Trustpilot
2 months ago
2 days ago