Essie Spot Resist Stainless Pulldown Sprayer Kitchen Sink Faucet Set with Modern Pump Soap Dispenser, 87014SRS

This Moen faucet is wonderful because: It's extremely simple to install, looks great, is truly spot resistant compared to shiny stainless faucets and has great water pressure. The soap dispenser is cool too. This setup replaced a 10-ish year old standard faucet with a total of 4 holes in sink so the soap dispenser used the one where the separate sprayer hose used to be and the trim plate covered the rest.

LOVE IT! The faucet is very good. Strong high pressure on both the spray and one stream settings. The toggle button to switch between those two options seems much more durable than my last faucet and if you push and hold the top button down it stops the stream immediately and completely. No dripping or tiny stream still running. I like the on/off, hot/cold control lever. Seems very sturdy. I guess only time will tell. The soap dispenser is a nice addition although I never use it. Old faucet had one too. So much easier to just use a bottle sitting on the edge of the sink. Also I prefer the foaming soaps and I don’t believe they’d work in these dispensers. Just liquid soaps. I like the brushed look and love the hose nozzle option. My primary requirement in my kitchen sink. The downside to this design is that the hose doesn’t always cooperate when putting it back into the “neck” fixed position. So sometimes if you pull it out several inches, when you push it back into place, the head doesn’t want to stay put. I’ve messed around with it and gotten it to stay but I’d love it if there was a snap/lock into feature that when pushed back into the neck if the faucet, it just clicked and held into place. This is not an issue with just this exact faucet but with all of the “hose” designs like this. At least that’s been my experience with the last 3 I’ve had. Otherwise I think it works great and I love the “brushed” finish. Matches my stainless steel sinks, oven and dishwasher well.

Converted from a 16 year old 2 handle Moen over to this one. Installation was fairly simple by following the supplied instructions. Be prepared to put 2 supply lines, the hose line, and the faucet mounting bolt thru the 1.5 inch pre drilled center hole on top. It’s manageable but a little tricky. It’s a quality faucet with good water pressure. Don’t forget to register your faucet with Moen, which activates the lifetime warranty. Moen customer support is excellent. They will work with you in getting replacement parts out to you very fast. Recommend.

I purchased this stainless Moen Essie standard to replace my 6 year old leaky Kohler Capilano and am very happy with it. It has a simple clean design and installation took less than an hour with no leaks (unlike my prior install which took forever because of a rusty 20yo fixture). At 15.4" high it is a shorter than my previous Kohler. The pulldown plastic sprayhead feels lighter, but works well. The oddly curved handle takes getting used to but is sturdier than it looks. On balance, I think the Moen is better quality and a great value, but I wished I had gone for a more upscale model.

Ordered Monday (38% off); arrived Wednesday; installed by a local handyman today. Replaced an 11 year old Hansgrohe and this one weighs about half of what it replaced. (The Hansgrohe was part of a kitchen remodel and cost about 4 times what this Moen did.) However, it is the function which counts. - Got black to replace brushed stainless. Looks good but it quite a change. - Installation went well and was easy for the handyman (younger and more agile than I so he was able to get under the the sink much easier than I could). Only issue & not huge is that the special tool (essentially a very long deep well socket) for tightening the nut under the sink - holds the faucet to the counter - could have been longer to facilitate the installation with a deep farmhouse sink. (Hint #1: Go to the hardware store and buy a bolt and nut to fit the non-business end of the tool, then use a socket, extension, and breaker bar (or ratchet) on that bolt/nut combination to tighten. Using the screwdriver in the holes per the instructions is not the greatest. Hint #2 (from the handyman) save that special tool for the next person. I attached mine to one of the 2x4s which support the sink with a wood screw.) - The reflex system discussed for retracting the hose is nothing more than the weight attached to the hose under the sink much like any other sprayer installation. However, the hose does have a smooth fabric outer layer so the hose does run in & out smoothly. (Make sure to screw on the plastic end cover for the threaded shaft to keep the hose from fraying.) - The sprayer head is not magnetic as some are, nor does it have any sort of notch to locate it in a particular position when docked. - The hose does seem a bit short but is adequate to spray down all corners of the big farmhouse sink. Bottom line, looks good works well (so far, only hours after install).

Is a gorgeous upgrade to our kitchen sink. No issues and super easy to install

High quality, easy to install, came perfect!

Ignore the fact I needed to redo the caulking behind the sink. This was taken right after we finished a few months ago. This faucet is awesome. It was incredibly easy to install and has long length on the hoses. The funny part was that we ran into some "oopsie" moments when we forgot to remove caps that were covering parts (I guess to keep them from breaking in the shipping process?) that prevented usage. We have an older house where the faucet was NEVER updated so we had to do some cutting/replacing of metal pipes. It isn't perfectly centered; but, it was never perfectly centered to begin with. Appreciated that this faucet has a decent sized plate to cover up extra holes in your sink. We have used this faucet over many months and it doesn't show dirt like other faucets do. It runs well. It hasn't leaked. My one gripe with it is sometimes when it is on the spray function, the stream from one of the little things is just going the entirely wrong way. I just fix it by rubbing my fingers over it and coaxing it back into the right direction. I've also experienced the oopsie of holding my finger on the top of the faucet on the stop flow button and then accidentally spraying water everywhere. That is a user error 100% of the time. I get confused on which part does the spray and which part stops the flow (because it's all one button). The soap dispenser is awesome too - you dont have to crawl under the sink to refill it, just lift up the top of the dispenser and pour directly into the bottle. Makes for easy cleaning as well.

Tuve que pedirla dos veces, ya que la primera vez me la mandaron incompleta. Cheque videos y reseñas de Amazon USA y me di cuenta me habían enviado la primera vez sin bote para el jabón, sin la placa adicional y sin instructivos. La tuve que regresar y está segunda vez que la pedí excelente, viene todo lo que dice que trae. Adjunto foto de referencia de todo lo que debe traer.

My previous kitchen sink faucet was moen and it lasted more than 20 years. And this is the upgrade. Amazing quality. Works as expected and it was easy to install. No complains whatsoever. A great peace in mind purchase for the coming decades.

The one originally delivered was defective and was returned but replacement was cancelled due to its delay but I love this unit.

Easy to use very durable

El producto llegó en excelentes condiciones. Teníamos dudas sobre el diseño pero nos encantó. Tuvimos que comprar unas conexiones extra para las mangueras de la llave hacia la toma de agua. Es importante indicar que es una placa ahorradora de agua por lo que el chorro no es tan grueso, sin embargo nos gusta mucha.