Motorcycle Lift Scissor Jack, 1200 LB Capacity Wide Deck Hoist Stand Maintenance Bikes ATVs Garage Repair Center Stand Lift Jack, Black

Exactly like description says worked great no issues.

I bought this to work with my Yamaha XT250 which does not have a center stand. I use it primarily for lubricating the chain, oil changes and any time I need the bike upright. The XT250 being essentially a dirt bike with lights, sits at a steep angle on its side stand making checking the oil level almost impossible. To use this lift, I put a 2x6 under the side stand to get it to stand up a bit more, and I use an impact driver with the supplied socket (nice touch!) to run the lift up to position on the bottom frame of the bike. As it lifts up, I just hold onto the seat or the handlebar as it's lifting up, and it's lifted, just like that! I see that they rate this lift at 1200 lbs, and it might actually do that, but I think it will lift just about any motorcycle on the market. It's fairly heavy and seems to be well made. My bike is light at just 290lbs, but this lift will do the job for just about any bike, at least in my view. I would buy it again!

I wanted something I could store easily and was small. This is perfect as it folds up about 6” thick so I can stand it up and shove it in a corner out of the way. It comes with a 22mm socket. To hold the bike, it was not sturdy when placed long ways with the bike (parallel under the bike) but was extremely sturdy when placed perpendicular under the bike. I was able to take my rear tire off without concern after a few minutes of wobble tests. If you’re looking for something that works and is easy to store, this is it.

It's definitely worth the money. I initially bought it for a Honda Navi, and have since upgraded to an xr150l, it easily lifts 3 hundred pounds bikes, the rubber on the top makes it very grippy so the bike doesn't slip around while working on it. It's lightweight and easy to move around, (I keep it tucked under the toolbox) super easy assembly, because it's ready to go right out of the box. I give it 4 out of 5 because you have to favor the side of the life that the scissor stops on in the up position, otherwise the bike will have a bit of a lean when it's up. Otherwise well worth it. It takes a beating.

Sturdy and heavy. I like the weight, it doesn’t move holds my bike with no problem

Good

Bought this so I could work on my m50 boulevard. It handles the weight of the bike easily and is fairly stable. I was able to do an oil change and replace the breaks on my bike without any issues and I never worried the bike would fall.

My Harley I'm sitting on it now .workngreat