Easycargo 12 Packs TO-220 Heatsink + Insulator/Mounting Kits for LM317 LM317t L7805 L7812 L78XX Voltage Regulator, IRF Z44N 3205 520N 630 1404 MOSFET Transistor (20mm x 15mm x 10mm) (Silver 12 Pack)

Exactly as described. Excellent quality. Very happy with purchase.

These seem to work decently. One word of caution when using with the LM317, you’ll need to probably add a shim (see image, I used aluminum folded from a soda can) to get it to really press against the heat sink. They work fine for the 7805s. Here I’m dropping 9ish volts to 2 volts at about 0.3A so it’s dissipating roughly 2 watts. This heat sink kept the case temp at roughly 81C with about 22C ambient. The third image where I circled with the red is where I took the case temp.

Had a small project that is using the L7805cv 5v regulator. This chip is not really known for efficiency, so even at a few milliamperes it gets hot to the touch. This heatshink seemed like the best option out there. The build quality is good and it tightens down nice. Some mentioned that this will not work with breadboards, I was not able to remove the support pin, but I was able to bend it. This makes it good for prototyping and potentially PCBs if you don’t accommodate for the pin hole.

These are a good, cheap heatsink for TO-220 components like LM317 and 780x up to about 800 ma. They come with mounting hardware and precut silicone insulator. Suggestion: for higher power devices use a silver-bearing paste instead of the precut silicone, and take a moment to sand the back of the heatsink with 600 grit until you get to bare metal. This makes a world of difference and your device will run considerably cooler. Decent quality, especially for the price. Will buy again.

Perfect high quality heat sinks

These heat sinks seem to do their job. I have missed them on a couple of devices that I have built, whenever I have a voltage regulator chip, it definitely calls for these. If you are planning on using one in your project just make sure you put some electrical tape on the proto board under it to electrically isolate it from the other lines. It's conductive and can short out your circuit if you're not isolating it electrically. Particularly an issue when using proto boards.

It is what it says it is

We needed to build a school project from scratch and this heatsink fits a 2 amp 5 volt regulator and worked out great removing the heat. The project was multi port USB charger that worked from AC/DC or solar cell.

they fit the TO-220 transistors properly but because of how my projects transistors were mounted I had to modify the attachment... Easy to do and they do their job

TO－220型トランジスターやFETに3端子レギュレーターを使う際には、シリコングリスを用意するだけで良い コスパに優れた商品。

Kit ben fatto. Li ricompro di sicuro.

Très efficaces pour dissiper la chaleur des certains transistors de contrôleur ebike dépourvus de dissipateurs. Améliore la fiabilité du composant. Nécessitent des pads thermiques.

Good assortment for the money