Force/Rival/Apex 10 Speed Rear Derailleur Pulley Set

Works as advertised. Very easy to install, spins well with low friction.

These pulleys fit perfectly on my SRAM Red 10spd. A lot less expensive than the RED specific pulleys, and since I don't need the lowest weight or the best bearings, I'm satisfied with these. I will note they came with a few options of shims, but I just re-used the ones from my stock, cracked SRAM Red pulleys. Would definitely recommend these.

Purchased these to replace the existing pulleys on my Sram Red derailleur after identifying a radial crack. There are two differences between these and the red version. The red have ceramic bearings and the pulleys have cut-outs to further make them lighter. Unless you are really concerned about weight, functionality is identical. In addition, the old pulleys cracked right at the cut-outs so I expect these to be less prone to cracking. Note: If your old ceramic bearings are still good you can always swap them out.

As I was going through my bicycle (2010 Pinarello FP2 with SRAM Rival groupset) I noticed the old derailleaur pulleys were both cracked. These are a perfect replacement. I was reading it's not that uncommon since the pully is plastic and it appears SRAM changed the design slightly maybe to address the issue. Installation is super simple but make sure you check the positioning as they are directional.

My pulleys on my bike disintegrated - SRAM Red Groupo. Sticker shock when I found that the exact replacements were over $150 (ceramic bearings). I am not a competitive rider, and I found on the web that these would fit just fine, so I bought them. They work perfectly. Now, to be clear, I'm sure my lap times have increased by .0000001S , but I can live with that.

Shifting seems a bit better. One less thing to consider in a 12 year old, ~10k mile bike.

The ones I received were in SRAM OEM packaging. As others have stated, these are a perfect low cost replacement for 2012 SRAM Red. Just be sure to keep your existing bolts and washers (washers are not the same ID). Replace cracked pulleys at a fraction of the ceramic red cost, and no difference in shifting performance.

The pulleys wheels on my bicycle have 2 different sizes, this came one size. I was only able to replace one. Did not return cause I had already installed it and got oil in it. Did not match description

This is more durable replacement for my broken SRAM derailleur pulleys.

Came in two pairs. Although only one of my rear pulleys (upper) needed replacement, I replaced all two together for a brand new look.

Habe genau das erhalten, was ich bestellt habe und die Rollen passen perfekt.

Until I found these, I was trying to make do with a Shimano lower jockey wheel to replace a seized SRAM on my RIVAL rear mech, but I couldn't replace my failing upper jockey wheel. Shimano jockey wheels use bushes, they are wider and both wheels are identical, whereas SRAM jockey wheels use bearings and the upper wheel has a thinner axle than the lower one. Consequently Shimano jockey wheels are more robust and slowly wear out but SRAM wheels run better if maintained but fail catastrophically.

Pulegge uguali alle originali, basta sostituirle, cambio SRAM force 10v