Question 1

I received this as a gift and find it does not fit in my miter slot.  Are there any replacement miter slot "runner" for purchase or does one make one?

Accepted Answer

It wouldn't be that difficult to make a new bar from either wood or HDPE (like an old cutting board)

Question 2

Cannot get my jig to tighten down in the miter slot. Slot is 3/4 by 3/8. Saw is a Kobalt K-1015 jig slides in slot no matter. any ideas?

Accepted Answer

I had this problem and after careful examination of the jig, I determined that the screw on the bottom side of the miter bar was bottoming out before spreading the miter bar sufficiently in the miter groove on my table saw.

I was able to easily fix it by adding another washer between the plastic star knob and the upper sliding ruler.  Now, it holds the jig firmly and tightly in my Sawstop table saw miter slot.

If you decide to try this, just remember to keep the OEM plastic washer lowest in the stack, so it’s the one that contacts the thin-cut slider. It will compress a bit,  aiding tightness and will not mar the jig surface.

Question 3

My Bosch table saw has the miter slot further left than some, how far out does this thin rip extend from the miter slot to saw blade?

Accepted Answer

It will extend over approximately 6", from center of Chanel to roller.  I'm using it on a Ridged portable table saw.  I think the smallest rip I did was 1/4".  From the center of the channel on my saw to the blade is approximately 6 1/2".  Hope these numbers help.

Question 4

What is the distance from the roller tip to the leading edge of the track guide?

Accepted Answer

The adjustment range I get with the "Thin Rip Table Saw Jig" is:    1 5/16"  to  5 3/4"
As you asked, this is from the leading edge of the Track Guide, to the tip of the Roller Bearing.
Just keep in mind that these measurements are taken with the Track Guide out of the miter slot. In my case, this guide fits loosely in the miter slot, before it is tightened down with the knob. I use this on a Rigid R4512 Table Saw.

Hope this helps...

ASIN	B0048J720U
Batteries Included?	No
Batteries Required?	No
Best Sellers Rank	#84,855 in Tools & Home Improvement ( See Top 100 in Tools & Home Improvement ) #97 in Table Saw Accessories
Blade Length	20.3 Centimeters
Color	Chrome
Customer Reviews	4.4 4.4 out of 5 stars (1,720)
Date First Available	October 22, 2010
Handle Material	Aluminum
Included Components	Thin Rip Jig
Is Discontinued By Manufacturer	No
Item Package Quantity	1
Item Weight	1.25 pounds
Item model number	3096
Manufacturer	Peachtree Woodworking Supply Inc.
Material	Aluminum
Part Number	3096
Power Source	Corded Electric
Product Dimensions	4 x 3 x 3 inches
Size	Thin Rip Jig
Special Features	The Thin Rip Jig

Thin Rip Table Saw Jig for Narrow Cuts – Adjustable Thin Rip Guide for Precision Strip Cutting, Table Saw Accessory for Woodworking

Details

Details

Description

Specifications

Common Questions