InnoGear Adjustable Desk Microphone Stand, Weighted Base with Soft Grip Twist Clutch, Boom Arm, 3/8/'' and 5/8/'' Threaded Mounts for Blue Yeti and Blue Snowball, Kick Drums, Guitar Amps, Black

Awesome addition to my ham shack. Mic mounts easy and can be adjusted to just the right spot. Can quickly move the mic out of the way when needed. Base is heavy enough the be stable between +/- 75 degrees from the base centerline even at full extension.

This mike stand is the best one I have purchased. Easy to use and handle. My mike fits very well. The stand is highly portable; it's very durable and sturdy. I believe it will last for years. Glad I bought it.

Good quality, adjustable and fit most microphones

You can freely swivel the arm, it's good and stiff but not to stiff, it stays in place where you want it. The base is nice and heavy. You can't swivel the arm to the side otherwise it will tip over though, at least with a blue yeti it will. It doesn't give no indication of that on the product page, but it says to keep the arm over the base in the manual (just a heads up). And with that being the case, to get the microphone out of the way you have to either turn the whole thing, base and all, or you can raise the arm up or slide it back. But if you slide it back you have to have room behind the microphone, so for instance, no wall. As for the measurements, the pictures indicate a 17" arm, but realistically you have only about 5 1/2" fully extended (Pic). With my Blue Yeti I have about 13" altogether. So just measure how tall/long your microphone is and add 5 1/2". This is because of the base itself and how far back the base of the arm is. The arm has a little wiggle room, so if you where to raise it up, it will tilt down slightly, not a big deal but just for the OCDer's out there, you will notice a slight tilt (Pic). One more thing to note, after waking up in the morning I noticed it had dropped slightly. So I don't know if this will worsen in the future, but I will update my review if it does. All in all, I'm happy with the purchase. It got it for my son and he loves it. You don't have an arm in front of your face blocking your screen while gaming. It stays at mouth level (or wherever you want it). It has clips to keep the wires out of the way. 4 stars because of all the little things that I notice but my son doesn't (ha).

Pros: - Heavy base, very capable of holding microphone with arm fully extended. - Strong hinge. I never experienced any give with the weight of my microphone, the AT2035. - Comfortable locks. Locking mechanisms are easy to tighten and loosen. - Height. Height is adequate for having the stand on a desk. - Feels like it will last -if treated well, of course. - Clean. It looks sleek. I like the turn lock, its minimal looking. - Comes with a microphone holder and screw adapter Cons: - U-clip Fragile. The smaller clip on the top axis broke with little effort. I received the product and I attempted to remove the clip with even force as to not pull it apart. It broke down the middle. I contacted customer service and told them that part broke and if they could send me a replacement part. They shipped me a new replace stand. The clip broke on that one too - on the first try. Perhaps its me, and I dont know how to remove clips. But I think I do, as I have had no problems with the bigger clip. I resorted to using a Velcro strap as visible in the photo. Its not a deal breaker to me as I could get a pack of these, but its a bit disappointing.

I have been podcasting for almost 6 years and I was looking for a good strong and well made stand for our mics. When I installed and created my home studio it was so nice that these have a good size to add to a small table. They are a bit heavy actually for their size, but it's very good material that it won't break easily. It is also really easy to just put the mic on these to hold the mic. One of the smallest challenge I had was that it had a small loseness to it so when I wanted it to stay in place sometimes it would start shifting or moving lower and lower, but other than that it's such a good mic stand for the price!

Well built, nice stand

Why did you pick this product vs others?: All the adjustments are sloppy. The main boom is smaller than its fitting, so it wiggles and wobbles and droops. The clutch on the upright pole doesn't grip tightly. Everything is loose which makes adjusting a pain in the ass. If you want to target the beater inside a kick drum for example, you have to adjust high to compensate for sag. Base could be heavier, when getting into a kick, the foot needs to go sideways to get closer to the front head, but then there isn't enough weight to keep it upright.

Really happy with the stand. The base is weighty and removes any tilting risk.

Fantastic stand. Solid base, perfect

Coloqué un micrófono con su antipop y resiste perfectamente el peso. El tamaño es muy bueno para que el micrófono esté cerca de ti al hablar y sin tener que hacer agujeros o dañar tus muebles. La base es de espuma suave y aisla el ruido que pueda viajar por el suelo. Pros: es resistente, fácil de ajustar y súper estable Contra: no recomendado para estar ajustando a cada rato ya que se fija con los tornillos incluidos, no con una manivela como un tripie u otro mecanismo

للاسف مايثبت المايك مركب عليه مايك بود وكل ما ارفعة ينزل مع اني شاد عليه

Excelente producto, de gran calidad. Ampliamente recomendable