TotalBoat Thixo Fast Cure Epoxy Adhesive

They have many variations of this handy epoxy system which by virtue of the mix nozzle can be accurately applied to the needed location like a caulking gun. Have been using this system for more than 10 years

Sets fast as stated and still cures in cooler temps, 50 degrees f.

I used this to fill spider cracks in gelcoat on my 40year old sailboat. I ground the cracks out with a Dremel tool and then ran a bead down each groove. It is a convenient way to fill the cracks, BUT… this stuff is straight epoxy with some secret ingredient; It stays where I put it and is harder than a rock and very difficult to sand down. If I did it over, I’d be sure to try to remove excess, right away or as it kicks. Or, I’d just refill with fairing compound or gelcoat paste. It’s a convenient product and I might use it for spot repairs or lamination in the future. It is a bit too expensive for large project use, especially since I’m working for myself and not passing along costs to any customer.

I used this product to fill in old transom holes. I prepared the holes by drilling them clean, applying expoy resin to the inside of cleaned hole allowing it to cure for 24hrs. Then I applied the Thixo thickened epoxy to fill the hole permanently. I also used Thixo to fill various old screw holes and chips in both wood and fiberglass. Before using the mix tips, squeeze the tube with your gun to ensure an even flow of material from both sides of the tube. Then put on your mix tips and use accordingly. Failure to follow instructions will result in uncured, soft sticky epoxy. Allow 24hrs for complete cure. Update: Using this product in high heat direct sunlight will cause the product to cure very fast within minutes, I recommend a cool 70-75 degree environment to allow for the time to dispense the product. I also recommend using a powered caulking gun to dispense for the quickest and consistent application of the product allowing for working time before is cures.

I absolutely love this stuff, it's amazing

I got a defective tube that appears to only have epoxy in it, with no hardener. I tried mixing it both with and without a mixing tube. Despite supposedly being hard in 4 hours, it was exactly the same pasty texture 24 hours later. I've used many tubes of their regular thickened epoxy, so I know how these should work. No returns or refunds, so I'm out $30+.

Excellent product. Keep in mind this contains FOUR ounces of product.

Product works fine, but if you are not using the nozzle then there is a lot of waste. The clear side was very runny so after squeezing out equal amounts, the clear side would run out of the tube. Very liquidy. Problem with that is when you go to squeeze out some more, about an inch of the other side comes out before the clear thus creating an unequal proportion. This stuff is too expensive to be wasting product on every squeeze out. Not allowing refunds I will go with the other brand.