Vertical Nozzle - Expanding Foam Can Nozzle Widening Up To 3 Inches. Ideal For Drywall, Foam & Insulation Spray (3 Pack)

Just ok

Didn’t fit the tube I had, after a couple of adjustments the item worked well.

Not the best think to use went everywhere but on the ceiling Where I wanted it to go

Cheap 3d printer crap..fell apart

Brilliant 🤩

Recieved quickly, looks like it will do the job fine 👌 ok quality

great help in laying spray foam neatly

The Foambeak works great for spreading spray foam insulation on flat surfaces. It would be impossible to cover a flat surface like the underside surfaces of a bathtub without it. As you see in the picture, the foam spreads in nice 3 to 4 inch wide bands, providing you know the trick. The trick? You must have the surface you are insulating parallel to the ground. If you try spreading along the side of the tub that isn't parallel to the ground, the foams just runs off due to gravity. It doesn't stick at all. So you have to orient the tub so that the surface you are spraying is flat to the ground and do one surface at a time. Then is works great. You will see in the picture that the tub is on its right side and I just used the Foambeak to spray the left inside surface which is parallel to the floor. Let it dry for at least 3-4 hours and then reorient the tub for the next surface. For the angled ends of the tub, I propped one end of the tub up on a step ladder. I used an old cushion to protect the tub. Be sure to cover everywhere you work with plastic as the foam insulation is impossible to get off of surfaces like wood without damaging it. Also wear latex gloves, you don't want the foam on your hands. It only cleans off with nail polish remover, do not use soap and water as these cause the foam to harden. If you are doing a large area like a bathtub, buy the Foambeak 12 pack. I had 2 Foambeaks with cracks that I could not use, but since I had 12 it did not matter.

I was skeptical from looking at reviews but after trying it out, I can't figure out why it got a bad review. It did just as described. It spread out the foam as stated and when I was done I let the foam dried and with minimal effort, the foam came loose from the plastic. No fuss, no problem. I would recommend this to anyone.

Had to modify to fit can nozzles.