Sealproof Power Whip Assembly, 1/2-Inch x 6 Ft Nonmetallic Liquid Tight Flexible Electrical Conduit and 10/3 Gauge Wire Single Phase Preassembled A/C Hook-up Whip Kit, 1/2"

Used for a mini split install.

These whips are strong, heavy, seal up tight and come with plenty of extra wire at both ends to hook up pretty much anything. As an added bonus they coil up nicely making it easy to get a clean professional look. I used three to hook up new mini split heat pumps at my house. They fit standard knock outs and the securing nuts are bent down slightly to keep them from loosening over time. They each come with one straight end and one 90 degree end. The ends tighten down with just a couple of turns so even if you do the 90 degree last it's still pretty easy to get it snuggled and sealed. I am completely satisfied with these.

Saves the aggravation of assembly and is decently priced.

This worked great for my new hot water digital timer. Summer hours this turns my hot water heater off at 2:55pm and back on at 6:05pm to avoid running the hw heater during peak energy pricing. Everything was included and it was very easy to install and setup. Only thing I is that I really wanted solid wire and this is stranded wire. My bad for not looking. I assumed that all 240 volt appliances and hookups were solid wire. Only reason I prefer solid wire is because I like the nice positive connection you get with solid wire to the screw terminals. Other than that it's a Great buy!Correction! I said I preferred solid but found out that the stranded 10 gage wire carries the same amperage as solid copper. The reason this whip is stranded is because it may need to make twists and turns in tight spaces and stranded is better for this purpose.

Liquid-tight conduit with 8-gauge wire already in it. Saves the hassle of building a whip from scratch for the A/C hookup.