WENHSIN 10Packs 4-Pin RGB LED Light Strip Connectors 10mm Unwired Gapless Solderless Adapter Terminal Extension

Worked with the led lights I got. Easy to use. Mine are hidden but you don't notice any change in the lights for the transition.

I have a Kasa led light strip and part of the light strip did not light up. I cut out the part of the light strip that didn't work and used this connector to connect my light strip back together and the light strip now lights all the way up.

Hard to open! When I can do it without destroying one I'm sure they'll work great!

worked perfect

TLDR: just take the extra step and solder the connectors together. This product has quality control issues. This product is nothing more than a quality of life product meaning it simply makes something easier. I create custom LED Lights and often have of pieces strips laying around that I use for another project. Normally I would solder the ends together where I need to combine two strip pieces together and everything was fine, life was good. One day while surfing the interwebs and specifically Amazon, I stumbled upon these things and thought it would be a huge time saver! I was wrong! The issue is with quality control of this product. Within the plastic snap casing (they can be hard to unsnap/open) there are 4 metal connectors, one for 12v (power), one for R, one for G, and one for B. The connectors are responsible for not only issuing power to each strip, but also controlling the color. The issue with quality is these connectors are not always aligned properly. Some of them are crooked/installed on an angle so they don't touch the pad enough to actually draw power. Additionally, some of them do not sufficiently apply pressure to the LED connector pads for the power to relay to the next strip. This will cause either no power to the next strip in the line, or colors that won't work. I've attached pictures to illustrate how this impacts the end product. In my pictures red is working fine but green is not. I am giving this 3 starts because I didn't have any issues on one project but on a 2nd project I fought with these connectors. There will not be a 3rd project as I am reverting back to soldering. In my pictures I installed the LED and tested each color as I installed. However, when I actually installed the LED and hot glued down, the issue manifested itself after I realized what was going on. Needless to say, I had to remove a bunch of LEDs in a otherwise finished product.

Easy to use and works great

Impossible to open

These actually work. The little guitar pick is useless, snapped immediately. Very carefully use a box cutter to pop the connector open. slide the box cutter under the 4 connectors to lift them ever so slightly so you can slide the LED strip into them without damaging the LED strip, and then use the back side of the blade to firmly (but gently) press the metal connectors down again. Close the clip. (I had to use a small set of pliers) it takes a couple of minutes. Clean and neat. Good solid connection. I will but this brand again.

جيد

La semplicità di utilizzo.

Sehr gutes Produkt kann ich nur empfehlen.

Very simple to use, I didn't have any issues popping the clasps open. Took me about 30 seconds to extend my strip light for the extra 2 feet needed. I just scraped about 4mm of the real adhesive away from the strip light so the 4 copper contacts slip under the 4 prongs easily. Nice secure fit, very discreetly extends the lights. Bonus is I have 9 other clips so used one of the others to put together the second set of strip lights I had to purchase for the extra 2 feet. No issues whatsoever, if you're extending strip lights, make sure they are the same brand. I used Tp link (Tapo) smart wifi lights

Works really well on connecting led strips, just make sure it is 4 connections. I used it to connect leds for underneath home theater recliners.