LATICRETE LATAPOXY 300 Adhesive #2 Unit

Came fast and correct. Bucket has two sets. You mix ingredient A and B first for like 4-5mins and then add component C. Mix another 4 minutes.. So bucket has 2xA, 2xB and 2xC. It also has gloves. It is recommended to use gloves while mixing epoxy. Stays workable for 1-2 hour after mixing. Sponges are included for cleaning after use. Make sure to clean tiles before hardening else impossible to remove thin set. Cheers.

It is easy to apply, but you must work fast as it sets quick. A must have for using in showers.

We use this product to adhere tile to the concrete floor. Works great. The shipping was great. Everything was delivered as promised, and then timely manner.

I researched extensively to find something suitable - and strong enough - to work with pool-edge coping tile. It had to adhere to both concrete and (roughened) fiberglass. Yes this stuff is expensive but you get what you pay for. It surpassed my expectations in all respects. Very strong indeed, and thankfully has a long work time (for an epoxy) which made laying the tile much less stressful than it might have been. Ended up using three tubs, but the tile will be here when I'm long gone.

Pros: premeasured and easy to mix; very little odor; pretty good cleanup with detergent water; easy to apply Cons: very expensive compared to regular grout (up to TEN TIMES); I used it for mesh resin-backed tile on top of Schluter's DITRA uncoupling membrane and it took a very large amount of material. I only got about 30 sq ft of coverage from one "number 2 unit" whatever that is; it will probably cost over $320 just for the grout for a about 55 sq ft bathroom.