TEW-AO46S

I had this product for 1 day and an antenna snapped. This was located outdoors at my apartment and not subject to any environmental factors outside of the ordinary. It was connected to a Meraki MR76 and while it worked fine, it was incredibly fragile. I tested this against Meraki, Cisco, AccelTex & Tessco models and there was no comparison as to hardiness, these are grade-A junk. Stay away unless you want to re-purchase on a regular basis.

So I have bough several sets of these antennas and have used them with Meraki MR62, MR72 access points. They seem to have a decent signal strength and have held up pretty well outside. I haven't had to replace one yet. They are a great value in comparison to the Meraki branded antenna's out there that are well over 100 bucks for a set of 2. Would buy these again.

Works as advertised. Appears to be a robust antenna and looks great.

Using these indoor with a Mikrotik Routerboard RB2011UiAS-2HnD-IN. I expected a dramatic difference between these and the factory antenna's. While I did see an improvement, it wasn't ground breaking but they do help.Still very good quality and very attractive!

excelente mercancia

Works great with my mag mount bases for a wireless heatmapping setup

They Work!

These antennas on a UAP-AC Mesh access point, with proper adapters, works great. I needed a custom solution where Ubiquiti's own antennas would not work, I needed omni in a specific form factor.For UAP-AP Mech, here are the adapters, they also are built well.  DHT Electronics RF coaxial coax cable assembly RP-SMA male to N female bulkhead 12''