07333 Impact Resistant Structural Adhesive Cartridge - 200 mL

Amazing stuff from a good company. Glued on rocker panels on a car with this.

great product

My father-in-law is a body mechanic he remodels very high-end cars when they get in wrecks he is the one that told me about this stuff if you are not used to using a product like this it can be a little overwhelming you have to make sure you are on complete level ground. Make sure that you can get something to the back side of the hole or where you're putting the body filler and make sure you can control where it's going if you're feeling a hole you need a little extra to come out that hole so it feels both sides and then put it in the hole but keep it in a controlled environment it takes a little while for it to set up but after it cures you better hope to God you did everything right because there's no change again when it dries. Biggest tip I can give take your time check two or three times before applying this product.

Product was on time and packed well. Anything 3M speaks for itself, don’t use off brands for something important.

I patched some minor sub frame rust on my 1954 Belair. I cut new replace metal and clean the surfaces used the adhesive as to the instructions. Its been a few weeks driving the vehicle almost every day and so far so good. No breakdown of the metal patches or the adhesive.