Perma Soft Denture Reliner Kit - Relines 2 Denture Plates - Semi Soft DIY Denture Liner for Upper and Lower

Before I express my positive thoughts , I want to acknowledge the taste of the product— yes, there is a bad taste at first. It does fade with time and it really doesn’t take more than a few days to go away. Soaking it in baking soda seems to help followed by my regular denture tables. Now, on to the good— first off, the product actually works. I’ve tried many other solutions for at home denture reliners. Including the $100 option from TikTok and also the drugstore option when I was in a pickle. This product actually lasts! I do not need to change more than every 3 months, you can tell it is time to change out when they become a little loose. I would also like to say— when the directions say to stir it then let it sit and check consistency every 10 seconds, then you should do just that. I find for myself it is best to let it get slightly paste the consistency of honey to make sure it stays on my denture. I always go against the manual instructions of doing one plate at a time, I feel that I get a much better end result and fit by doing both at the same time. I have consistently done it this way the last few times I’ve purchased the product. I use part of the second mixture to add to my top becuase it requires more product than my lower. When you put it in your mouth and bite down for 3 minutes don’t bite down so hard that it’s miserable, just slight pressure. Yes, some of the product will come out of the denture. Just don’t swallow it. When the 3 minutes are up, I take them out and follow the test of the process. I also remove any pieces that got on my teeth before going through the second round of water rinse. I would also like to mention that I am using this product for my immediate denture. Without it, they were useless. I get a much better reline at home by doing it myself than at the dentist. I found this to really help me. On one side of mouth, the immediate had a large gap from no edge due to swelling at my extraction. About half way in the first set, I use my finger to slightly mold that area to create that wall and then let it set for the remainder of the 3 mins then it really gets cured in the second round when you finalize your bite. Don’t skip the 20 minute air dry. I have done that every time and I think it needs that time to cure. At the start, I clean them really good and remove any old reline and then I clean them with alcohol. Then dry them so throughly. Also, one time I got them out of the mail and it was very cold out. I tried to do it right away from bringing it in, big mistake. It didn’t work properly. It needs to be at room temperature prior to attempting this. I would just like to recognize the maker of this product becuase while it may not be the newest or the fanciest option, it is very affordable and it actually lasts and it works. Get 2 kits the first time. It takes trial and error. And make sure it thickens up before putting it in the denture.

This is fast, easy and has made it so I don’t even need poligrip anymore! And for the price, I’ll stick with this! When you are doing the initial imprint, yes it taste bad. However, that taste doesn’t last. It’s worth it. It takes about 10 minutes start to finish. You will save so much money on adhesives! They have renewed my dentures to like new condition. Now I’ve seen some reviews where people said it won’t stick to their dentures. The only thing I can think of is, maybe they weren’t clean enough. You have to start with a perfectly clean denture. Soak it and scrub it and rinse it really well before you start. This is a very quick process that leaves you with a very durable denture with a good quality lining. You mix the stuff up, put it on your denture then put it in your mouth for three minutes and then pull it out rinse it with cold water and then and then check it then you’re good to go. It only took three minutes for it to solidify. I only have uppers and it works great so I saved the other half for next time we have to do it.

Only four stars as I've only had the denture in for five hours, if it stays this way I give it the fifth star. My lower full denture is about four years old, and the gums and bone have shrunken back making it ill fitting. A dental reline is expensive, so I have been using a product meant as an adhesive - Cushion Grip thermoplastic adhesive. It conforms to the shape of the gums and is supposed to last about four days. It does that, but one then gets bacterial problems as one doesn't take the denture out. I then went to using the Cushion Grip and removing the denture at night, but then one has to use Polygrip or another adhesive when putting it back in as the thermoplastic doesn't really set as a "reline".Every four days I had to heat the thermoplastic tube and reline the denture. The Perma-Soft worked beautifully, had my dinner tonight without any "glue" as the suction of the perfect fit held the denture. I expect that won't last, I'll have to put a bit of Polygrip adhesive on the denture as my gums continue to change shape, but that is no problem. This will not last the two years as advertised, nor will a dentist's relining if you are of an age. The reline may last, but the gums will change. I'm sold on this, even if I hit the lottery and could afford the dentist I'd stick with this. It gives me the control over my own mouth. If I have clamped down too heavily while setting it I can just do it again. At $25 for each kit of two applications I can redo it 20 times for the price of one dental reline of $250. It is far superior to the thermoplastic, as that doesn't set permanently and needs to be redone every few days. As to the matter of the taste while setting in the mouth, the instructions dictate two 3 minute sessions to set the shape, then 20 minutes to let it cure. I can stand a bad taste for 3 minutes, in my 77 years I've had a lot more bad tastes in my mouth. A good mouthwash kills the taste as soon as one takes the denture out for its external curing. There was no taste from it once the process was completed. Best, Jon

I was skeptical about buying this for my lower plate. I had to use 2 seabond films with denture cream to use them. What a pain to do that everyday. I got this in a fast time period and was scared to use it. After a few days go by I decided to try it. I had read most of the reviews and came to the conclusion that this takes longer than what the box says to harden. So I mixed just half of one kit. I stirred and stirred until I got a kind of jello consistency. At that point I filled my lower plate and put it on my gums. I waited an extra 5 mins or so before I took it out. While it doesn’t taste great it worked awesome! I let it set up overnight in water. The next day I trimmed what wasn’t needed. I used denture cream with scope to glue them in. I didn’t have that bad taste with that. They fit perfectly! They don’t move all day until I take them out. I have been using the same mix now for wks. I believe it will last many more before I will need to mix anymore. This product lasts a long time. I haven’t yet tried to remove this product yet, but I think I’ll be able get it off if I really need to. I’m very happy I got this product! I still have enough product to reline my dentures 3 more times. Yes it doesn’t taste great at first but now I can’t taste it at all anymore. All I can say is take your time and give it time to set up fair firm before putting it on your gums. And don’t push down hard, let it form to your gums and let it set up good in your mouth. It worked great for me and will buy again if I need to.

Don't need to be a chemist to use, easy to follow instructions, works effectively, and versatile enought to use on different size dentures. Very durable, outlasts the smile quickly fix. Sticks to old and new dentures easily.

This product works really well. Directions are easy to follow. The only reason I didn't give this a 5 star is because of the taste. The taste is awful. I figured it would go away after a good soaking, but here I am 4 days later soaking them all day and all night. I tried everything soaking them in peroxide, some good denture cleaner, mouth wash, and I even tried soaking them in 151 rum. The taste is still there, not as bad as at first, but still very noticeable. If anyone has any ideas how to get rid of the taste please let me know. Ill change my star rating if it works.

For the times that I have used it in the past I would give it a four star. Two weeks ago I bought it and when I used it, it didn’t seem right that is it didn’t seem to mix like it usually does and it showed when I went to put it on my dentures for the first time it did not stick to them I’m not sure what happened but I have to say it wasn’t me because I’ve used it so much before and it worked great then, just not sure what happened this time

I had read every review and totally psyched myself out…. Waited another week…. Finally after my face broke out from nerves i finally set a date and started the process. WHY? Fear i guess. JUST DO IT! I mixed it and stirred and stirred and stirred…. After much longer than i expected it started to thicken. Think smooth peanut butter. Even after i put goop into my lower i let it sit and thicken some more. I surely didn’t want it going all over my mouth. My lower is old and thin and didnt take much goop so i didn’t bite hard cuz i needed some buildup. Did the 3 minutes, rinse in cold water and back in just like it says to. In the meantime the extra goop started setting up. Almost like silly putty. I didnt want to waste it so I rolled it into a log and laid it into another lower i had been trying to break in. They hurt and i had been using a dremel to get it to fit so i figured what did i have to lose? I pushed the roll into the groove and put them into my mouth and did bite down more til it almost felt like a pillow surrounding my sore gums. So following the directions til the second bite and then into cold water. OMG that stuff is nasty. So i let them sit the 20 minutes to cure and then dumped half a box of soda on top of them. Add a little water to make paste and keep putting it onto both lowers. I let it sit in soda for over 24 hrs. Then i added toothpaste right on top of the soda. After another half a day i can almost stand the taste. The lower i put the roll into definitely looks weird but ask me if i care. I got two lowers much more comfortable with one little tub of the powder. I can hardly wait to see how long the reline lasts. I expect i will need to add another layer to the first lower that i did the conventional way. For now i can only tell you to jump in and do it. It’s amazing how well it works. As others have said, I‘m sure it will be much easier the next time i get to play! As for easy to remove…? I have no idea. Taste? Ugly. But its sure nice to have my lowers relined and feel less pain. Try this stuff if you have old dentures and not much bone left. It really helped. I might have to do it more often but its like a miracle to me right now. So worth it!

se cae después de una semana, pero está bien

Great stuff! Easy to use

Bit messy to use

I was cleaning excess of for ages after. The taste is awful. Absolute rubbish

Tried making dentures better fit didn’t work removed but now dentures painful as some did not come off