Prime-Line R 7211 Drawer Slide Kit – Replace Drawer Track Hardware – Self-Closing Design –Fits Most Bottom/ Side-Mounted Drawer Systems –17-3/4 In. Steel Tracks, Plastic Wheels, White (1 Pair)

I was leary of the price and some of the complaints I had read about these, but I took a chance and purchased 2 sets for some new cabinets I had built for my bar. I was going to go with Liberty slides which I had used in my kitchen cabinets, but 20" slides were almost 3 times as much as the Prime Lines. The Prime lines worked great. Easy install and smooth operation all the way down to the self-closing. Just as good as the Liberty. If you have never installed drawer slides before you may have a problem since there are no directions with this product. I took the time to pre-drill all the holes and had no problem with the screws. All parts were complete and correct. A good product for a great price. I will purchase more when I build my pantry cabinets.

These are less expensive than the ball bearing models but for most purposes they are every bit as good. They are easy to install and work well. I installed 6 drawers in a vanity and I used scrap particle board cut to the height I needed for each drawer and they all came out at exactly the right height.

These fit fine and the dimensions are accurate. They do self-close the last few inches. They are easy to install, although the directions could be more straight forward. They were a little confusing, but correct. I gave them a 4, only because of two things. 1. I would not load 65lbs in my 10lb drawer and extend it all the way open. It will not hold up. I installed a stop limiting travel to 10" open. I feel it can take the full load at this distance. 2. I built a perfectly sized drawer and cabinet. The dimensions are with 1/32" everywhere. The flathead screws attaching the slide half to the drawer stick out at bit, and interfere with the wheels. Luckily I have a countersink bit and used it on the screw holes where the slider half attaches to the drawer to alleviate the interference.

This kit fit very well. A great value and quality product. I bought this (actually 2) to repair 2 drawers. The drawers are stable and glide in and out.

These were purchased to replace broken drawer slides for a three drawer cabinet by Ikea. These are a close replacement but not exact so some minor adjustments were needed. The slide attached to the drawer itself flawlessly. However, I did need to adjust the slide that is attached to the dresser down by a fraction of an inch so the drawer would close smoothly. If you have just one piece of the Ikea drawer slide that is broken (like I did) you will still need to replace both pieces on the same side since you cannot mix and match. I was still able to keep the undamaged drawer slides on the other side of the drawer. All you will need is a Philips head screwdriver and about 5 minutes this is an easy project and a perfect product to get the job done. I also found it easier and cheaper to purchase this product from Amazon and save myself a trip to the local home improvement store.

Great replacement for contractor grade cabinet drawers. All screws provided, holes lined up. Easy install. Metal is sufficiently thick.

Like the price. Like the end result. Easy to install. Definitely not for heavy use like a kitchen or a drawer with weight. Installed in a dresser so should be just fine for my application .

Very easy to assemble. Slides in and out with ease and little to no noise, just like the original one. High quality, highly recommended!

These are great, and the drawer piece has a flap (along the entire length) that supports the bottom of the wooden drawer frame. Other similar ones don't have this long flap, hence offers no additional support for the wooden drawer frame bottom.

Well made and saved us a costly repair on a kitchen cabinet drawer with broken slider wheels. They seemed like a perfect match, but must be a touch thinner than the ones replaced as the drawer was falling off the guide. I inserted some thin washers behind the rail and.... problem fixed! Note: I installed these several months ago on a pots and pans drawer which is used often and have had no problems. Very happy with this product!

من ناحية الجودة فالحديد قوي و ثقيل

Compré estos rieles debido a que tenía que remplazar los que tenía un cajón de la cocina. Además de ser mu faciles de instalar y viene con unos tornillos para madera pequeños, me quedé sorprendido por su suavidad a la hora de usarlos al abrir el cajón. 100% recomendado.

Perfect fit/replacement. Almost like the original used by the carpenter.