🔧 Elevate your pressure sensing game with precision and durability that professionals trust!
The Flylin Pressure Transducer Sender Sensor delivers high-precision pressure monitoring with ±2% full scale accuracy, supporting a wide range of fluids including oil, fuel, diesel, gas, water, and air. Engineered with robust 316 stainless steel and a ceramic pressure chip, it withstands harsh environments while providing a reliable 0.5V–4.5V linear voltage output. Its compact design and water-sealed quick disconnect connector make installation effortless, complemented by built-in surge voltage protection for safe, long-term operation.
| ASIN | B09WRP4DYZ |
| Item model number | 202216 |
| Manufacturer | Flylin |
| Product Dimensions | 9.91 x 7.62 x 1.27 cm; 40 g |
A**T
Used to replace the one for my glow shift 30psi gauge and it worked I had the re-wire the original glow shift harness and solder onto this connector but works with the gauge been using if for a few months and all seems good!
J**.
Worked perfectly to add fuel pressure on my Holley Terminator system for my LS swap and is accurate.
B**E
This is an inexpensive part, but works fine and arrived on time. I measured the current draw at about 2.35ma continuous, could be used battery operated, would be fine for low pressure air line, water line, etc. Accuracy ok for most uses. Connector is nice, would be about the same as the whole sensor if purchased separately.
M**R
The pressure transducer worked great fro my LS swaped Trans am to run my aftermarket gauges. It was nice to have the wire pigtail.
C**A
works as it should
Trustpilot
Hace 1 mes
Hace 2 meses
