PANSHIYON Bit Driver,3 Pieces 1/4-Inch Strong Magnetic Bit Holder Handle, 1/4...

Nice feel and good value

The good: Cost is low - I need multiple because grand kids lose things ;-). Handles are comfortable & grippy. Length & OD are good for tight places Issues: The magnet that holds bits in could be stronger. The hole that bits go into is slightly looser than others I've used. Overall fine for what I need, but professionals might want better.

I've had many bit holder screwdriver handles over the years that were junk and would suffer through trying to just get by with them .I feel like I have found a possible winner with these , as any tool person knows ONLY TIME WILL TELL . These seem to be stoutly made , good feel and fit in your hand ,strong enough magnet to hold any length bit There are SO MANY different fasteners out there , it makes more sense to me to have a reliable set of handles and have different kit sets of bits .

Great for using your bits by hand vs your drill. It’s magnetic so the bits stay put.

Like most of us I have tons bits and needed a way to utilize them. These do the trick.

I have collected dozens of magnetic screw driver bits over the course of many years, but I only had one or two decent bit holders. I bought these because I wanted something inexpensive to build up several tool kits for different cars and use around the house. The price is right for three of these, the handles are comfortable, and now each tool box/bag I have has a screw driver for just about any standard type screw head.

I purchased the 3pack of these handles/drivers & 2 of the 3 broke within minutes. VERY cheaply constructed. Do not purchase.

I was frustrated with not being able to use my cordless drill bits manually. Sometimes you just want to have the control that comes from turning the fastener by hand. With one of these drivers I can start screws where a little care is needed and also back out screws manually without stripping the head. I also have an old cordless diver kit that long since given out. The bits were fine though. I just put one of these drivers in the driver kit in place of the old driver and the kit has a new life. I can say that this driver has an ample and comfortable grip and the magnetic bit holder has good fit and retention. I’ll say it’s a good buy. Keep one wherever you’ll be using hex bits.