Lowenergie Occupancy Sensor 360 degree PIR Motion Light Switch Ceiling Mounted 1200w max

Brilliant works well easy to install &set up

I would not recommend for a bathroom environment, I probably cannot fault the sensor too much, it worked great for 12 months, but started to stay on because the contacts stuck together, the only way to turn of was to give it a few sharp hits with my long shoe horn. Its now replaced by a different model, I may try to use this in a non damp environment. Also beware to fit this you need to provide an extra cable from the light fittings location so the unit can have its own permanent live power source separate to the light and then provide power to the light with its live and neutral via the switch, you may need an electrician if you cannot work out the logic for wiring this, it is simple once you work it out. Please don't use what I've written its not a wiring guide.

About 5 years ago I fitted a PIR mains switch in our hall to augment a pre-existing light switch. That switch, like this one, cost under £10, and has worked perfectly ever since. This weekend, the "old" PIR stopped working, which isn't too bad after 5 years of day in / day out usage. This switch exactly duplicates the old ones' structure and functionality, so I didn't even have to mount a new plate. I just turned off the mains, unwired the old one, wired in the new one, and turned the mains back on and it all worked perfectly. Very unobtrusive way to save money on electricity and to streamline life

Installation was easy and the product worked fine for about 6 weeks, but then stopped working. The only contact for the seller is a web form, which i have filled in asking for a repair or replacement however i have had no reply. Very disappointing

This little device solved a very impractical problem that I've put up with for years. My dinning room has a door in opposite corners, but only one has the light switch next to it. This resulted in me having to make at least one journey every night in the dark. This was never rectified, due to having to rewire the circuit by taking up the floor above the dinning room and cutting a channel into the wall. This device which was connected via the light celling rose, allows the circuit to be left on. The light automatically comes on and turns off after no movement is detected. There are 3 settings to adjust for sensitivity, the amount of ambient light before activating and duration the light stays on after no movement is detected. The unit looks no more out of place than a smoke detector. The only issue was for my installation, I had to extend the wires slightly. Also the compartment for the terminal block is a little tight. It serves the purpose of being energy efficient when nobody is in the room, and for me it means no more walking into the table or tripping over something I have left on the floor.

Very good item does what required

Burnt in a few months . Only used for one LED light bulb

Works well good job

After few weeks it starts turning on and off without detecting nothing. Rubish and no refund

Il rapporto tra il costo e la qualità è rispettato, consigliato. Estremamente facile da montare e per il momento stabile