3 Inch Round Led Recessed Lighting Trims,Dimmable Spotlight Downlight Holder, for GU5.3/MR16/GU10 bulbs , Retrofit Eyeball Light Fixture Frame with MR16 sockets, 70mm Cutout, Pack of 2 (White)

So after installing the unit I had to write a review to rebuke the negative reviews. The people that could not get the bulbs to fit were trying to put them in from the back. To install the bulbs the front bezel must be unscrewed and then the bulb inserted. It is very well made and the fixture looks amazing.

Superb quality. Some reviewers that expressed fitting issues with some bulbs haven’t realized that you’re supposed to unscrew the front lip/rim. These fixtures fit perfectly flush with all my MR16 GU5.3 low voltage bulbs. I ordered “10 Pack Bioluz LED MR16 LED Bulb 50W Halogen Replacement Non-Dimmable 7w 3000K 12v AC/DC UL Listed Pack of 10” and couldn’t be happier

Product rotational joint comprises two machine screws that are not supported by any mechanical structure. Screws threaded through brackets, then into bulb support ring. However large space between ring and bracket is left open, with screw threads suspended in air over approximately 3mm on each side. So bulb support ring is basically held in place by two 'floating' screws. Assembly does not stay fixed with bulb support ring becoming loose contently. Very poor engineering approach for bulb pivot design, useless.

I installed 10 in a ceiling. Makes for a neat, compact look. QC is not perfect however. Two of the fixtures had mounting rings that were cross threaded and therefore unusable. Another two had loose tilt control screws that was easily remedied. They require a 3 inch mounting hole to fit the spring mounting clips and allow swivel adjustment. Most came with a socket for a low voltage MR16 bulbs.

At about $7 a piece this is expensive but given that there is no other similar product (at least I could not find at the time of my purchase in April 2022) it is worth it. I initially bought another product which was very flimsy and bent when I tried to pull the springs to install it. These are made of sold aluminum. I installed these under the soffit. The lights looks really nice.

The Outer ring that holds the bulb in place is extremely difficult to thread. Depending on the actual bulb, it might be impossible. Even without a bulb in the trim assembly, it is very difficult to not cross thread the outer ring. Good construction, poor design.

Easy to install

Great quality

High quality, fast delivery

they seem well made and work as expected. removing the outer ring to place/replace bulb may require a bit of work because it is fine thread and fits perfectly in the socket and there is no tab or key. Happy with them.

These things are the cats ass for indoor or outdoor recessed LED's. EXCELLENT PRODUCT...Thanks