2 Pack 2-Pin PC Power Switch Cable 27-inch Desktop On Off Reset Push Button ATX Front Bezel Wire with HDD SW LED Indicator Light for Desktop Computer Case

I have been building my own PC's for over 20 years, I'm always looking for some particular cable or another as each case manufacturer (and motherboard Manufacturer) has their own ideas of which connectors they provide or have and in the past some case manufacturers used to provide a robust quantity of cables. The ones here are for the On/Off, Reset, HDD Switch lights on my case. I always like to have an LED HDD light, sometimes I need to use an outboard connector with a light as not all case manufacturers provide them anymore. I like to know when the HDD is reading/writing or if there is no activity it means the PC may be stuck and needs a re-boot. These worked well, were plenty long enough for a good size Tower case to motherboard connection. The connectors fit snugly, were easy to install and to remove too.

Generic switches and LEDs for PC case. Cheap, and they work. Most generic sets are the same as this. The LEDs are perhaps on the large end of the scale, these days. Nothing wrong with that! When my computer stopped turning on, I could have bought a whole new computer. Instead, I tried replacing expensive computer parts that weren't the problem -- the CPU, motherboard, power supply. Turned out to be the "On" button that broke. Since that's built into my computer case, I had to get funky with a screwdriver and take the case apart. This kit was the easiest way to replace the little electric switch that the big fancy button built into my case actually pushes. Kit comes with a "power" switch, a "reset" switch, and LEDs for "power" and "HDD". These "momentary on" switches merely connect the two leads while pressed. As you can see, the "power" and "HDD" LEDs are different colors. You don't have to use every one of the switches and LEDs -- just zip off the ones you don't want. 2 kits for $6 is 50x cheaper than a $150 computer case.

they work nice but the color sucks, make them in black so they dont stand out

They were much better than what comes in an actual case and there are 2 of them. I'm happy that the wires were shrink rapped really good around the switches more, where ones in the original case, do pull out, but not these. You have a second set if you should need it on another case. Better have it and not need it or need it and not have it. Be careful though with the switch tops, they may not match your buttons that attach to the switches. Mine did not, but I was happy with the power cords.

These case LED's and switches are exactly what I needed. Leads are plenty long enough, longer than the originals, the LEDs aren't so bright it's blinding, yet not dull and they are properly marked and oriented on the board end. I was putting together a old school tower I had used from years ago that needed these parts and I couldn't be happier. They are exactly as the originals that went bad, even the color of the LEDs are the same. So nice to build back my old ATX case that's been sitting around waiting to be used again... I'm one happy camper 😁I highly recommend these case LEDs/switches but keep in mind they may not fit every case out there. The newer cases might actually have smaller LEDs which seems to be the trend now for some cases. If you have a older case though, these will more likely fit as they are the standard for older cases. I know this because I've been building computers for 20 years and for years nearly every case out there used these size LEDs, some cases still do. If you get these and they're the right ones for your particular case then you got a great purchase. Even though i only needed one set of these, at the price it's still worth having two sets, and now I'll have another set just in case. My moto is it never hurts to have spares, better to have it and not need it, than to need it and not have it... 👍

Works perfect good price

My power button broke on my computer and I didn't want to purchase a new case. This was easy to install and works great.

Handy for testing motherboards.

bonne fabrication tres util quand je veux tester mes carte mere

Buen producto, los plásticos y el ensamblado es de buena calidad y cumple su propósito para reponer los cableados de encendido de la computadora.

works perfect and im using one of the extra buttons for the CMOS reset when i try overlclocking :)

Es justo lo que esperaba, ya que mi PC se había cortado uno de los cables y este juego de cable estuvo excelente quedó a la perfección mi computadora vuelve a revivir después de mucho tiempo sin uso

Buen producto y les debo la foto por que ya entregue el equipo