Question 1

Are these anything like Seabond? (I've tried Seabond, which for me don't hold longer than an hour or two).

Accepted Answer

When using them first you must trim to fit then wet throughly put it against the denture then into your mouth and it feels sort of like a thin piece of cardboard. After 15 minutes or so it starts to feel like it is part of the denture and not a piece of cardboard.  Seabond to me never became part of my denture and never seemed to get thicker where EZO does. Hope that answers your questions my only caution is don't line the top and bottom at the same time unless you can keep your teeth together without speaking for about 15 minutes!  

Question 2

Just got mine and have tried four times and none have stuck.  what am i doing wrong? warm them first, even tried warming denture one time.

Accepted Answer

Be sure to run very warm water on your liner. fit it inside your plate Trim to fit. Now push it back into plate and run warm water on it again and put in your mouth push on your plate for a snug fit. Just.. keep pressure on it for a few min .

Question 3

Why do they  cost $119.00 ? I only paid around $6.00 for them about 20 years ago

Accepted Answer

It was only two years ago they were two dollars. It's greed that's the reason. For about. $25 you could get a whole box which consisted of I believe there was six or eight boxes . I wish I knew why the company stopped making them. Supply and demand my ass. PURE GREED is why there so costly.

Question 4

Are the UPPER HEAVY CUSHIONS coated/contain parafin or wax so they can be molded after you run warm water over them?

Accepted Answer

parafin wax it says on the box. It works the best of any of them. I only use the lowers and it is very good..

Ezo Denture Cushions: Upper Heavy

Detalles

Descripción

Preguntas comunes