amFilm 3D Curved Tempered Glass for S22 Ultra Screen Protector Samsung Galaxy 5G 6.8 Inch, Fully Compatible with UltraSonic Fingerprint Scanner and S Pen, Upgraded Easier UV Gel Application(2 Pack)

I've tried many screen protectors over the years, this one is leaps and bounds better than its competitors. I watched the installation video 3x. During the process, I was doing this on my office desk and my cat jumped onto my lap at the worst time, (this 3 legged cat wanted to help) got the UV adhesive everywhere but on the screen. The way you remove the UV adhesive if it gets on the floor, if it dries, is with the UV lamp. But mine got on the floor via a freak event, totally my fault So I tried it again but his time on a granite countertop with my 3 legged buddy on my lanai. 2nd time it went flawless and it came out prefect, I didn't need to recalibrate the fingerprint reader, thanks to the kits installation metal fingerprint dome cover, this kit is well thought out and the mechanism to instal it is simple to use, and idiot proof if you follow the instructions, but not curious cat proof. No bubbles, no flaws, you cannot even discern if it has a tempered glass cover, nor does it compromise sensitivity, the S-pen works in normal and air mode at the same distance as without the screen protector. I asked amFilm if they would allow me to buy two more tubes of UV adhesive for future use since this was a two pack, instead they sent me a new kit, what a great company (and product) PS I needed a quality screen protector, as I just bought a stingray cellphone case, normally I use a Otterbox Defender Pro. While this stingray case is stunning, it offers almost no protection, so this tempered glass screen is needed. My newly adopted 3 legged cat is sorry he screwed up the first go, but cats do what they do.

TLDR: Stop shopping around - this is the protector you should get for your S22 Ultra (my wife has the S22 version and it's also great). UPDATE: After 6 months of having this installed I just accidentally tested this protector by dropping it on pavement screen first. The screen protector was so badly damaged I thought for sure my phone screen was toast. But I was wrong! My phone is perfectly fine. Combine that level of protection with the fact that after all these months there was no air bubbles or peeling - this is definitely the best screen protector I've ever seen. I have used several different types of screen protectors over the years. But lately they have just been awful. The last one I bought for my Note 20 was so bad I sent it back. Too bad too because I dropped my phone a week later, which is how I ended up with the S22 Ultra. This protector exceeds in all the important ways: successful installation, fingerprint reader compliant, and protection. First, the installation is not quick. Set aside 15 minutes. It's okay though - take your time and it's hard to screw it up. No air bubbles to iron out. No corner that's not flush. None of that. The guide they provide to facilitate installation makes this install lengthy, but in the end, you have a screen protector that fits PERFECTLY! Second, the installation actually takes the fingerprint reader into account. There's no weird circle or air gaps. I did have to reprogram my prints. But after doing that, the reader works just as well now as it did pre-install. Finally, this provides a nice shell of protection and is secure around the edges. I'm not going to drop my phone just to test this, but so far, no scratches and I feel better knowing my screen is safer now than before. I have tried at least 5 different types of screen protectors over the last 2 years (between my phone, my work phone, and my wife's phone) and these are so much better than the competition I feel like they should be in a different product category. Nothing else even comes close.

The video shows them installing the screen protector very easily, however, if you are like me and very anal about perfection when it comes to your electronics then you are going to take as much care as possible to install anything onto your electronic device (whatever it may be, in this case it's my Samsung S22 ultra Flagship phone). So for it to still come out incorrect is quite disheartening. When I purchased the screen protector it stated that if I showed proof of purchase then they would send me another screen for free if the install had any bubbles left on the screen. Well the very first one that I installed did exactly that, on the top portion of my screen there was a bubble and even though watchig videos and taking the companies suggestion of giving it 24 hours and the bubbles would work themselves out, it did not. So I was stuck with a awful looking bubble on my phones screen, now for some that may not be a bother, however, for me who loves his electronics and wants perfection out of his devices, whether it may be aesthetically or not, that is far from what came out. I told myself that this may have been my fault that it came out the way I did it so I did not write a review as I am now, instead I just followed the companies suggestion of registering the product and stating what had happened and that they would send out an extra glass replacement. Well I did that and I NEVER received the extra glass. Well months went by up until last week when due to me dropping my phone I had to change out the glass. I was excited because I had told myself that this time I would be able to make it perfect (Note: The first install wouldn't allow the fingerprint sensor to work, and I placed the weight on there as the company video showed). Videos I watched showed that the screen removal was very very easy, like eating a piece of cake. Well, what the videos don't show you is a screen protector that needs to be replaced due to breaks in the glass. God forbid if that is the reason why you have to replace the screen for, because let me tell you, it was a complete nightmare. It literally took 4 different 2 hour sessions, 100% alcohol, gloves (to keep from little broken glass pieces going underneath your nails) and a lot of patience to remove the original screen which hadn't even been smashed into pieces. Simply the top right corner had cracked a bit. So now for install 2, I watch the video again, I even went as far as doing this after a hot shower so that there wouldn't be any LINT, DUST OR ANY OTHER DEBRIS in the air. I followed the instructions EXACTLY! I was excited to place the new screen onto there, I saw visions of a smooth and beautiful screen WITH a finger print sensor that would work this time around! So I began my task at hand, *Warning* Graphic Content Warning, proceed at your own risk. I went as far as not wearing any clothes just to make sure Dust or lint would not come off of me onto the screen, then I began the lengthy process of applying the glass screen protector onto my S22 Ultra (The process probably takes a lot less time to install if you're not a perfectionist like me) I followed the instructions exactly as they do it. I watched the video simultaneously and was pausing the video as I needed during each step. So once again I get to the portion where I need to remove the tabs from the top and bottom slowly to allow for the glass to sit onto the screen, well just like the time before I removed the tabs slowly and as the screen sits onto the main S22 Ultras screen and you see the glue begin to spread and the glass sucks onto the main glass, suddenly at the middle of the phone and another off to the right, one below that one and to the left 3 total bubbles form. Now keep in mind that these bubbles are NOT at the same place the last one was. So all in all I have to say this product does not apply easily as they state and it surely does not remove easily (however, I'm not sure if they made that statement or not. The removal is my personal opinion.). Also, when I applied the second screen the phone dropped from a height of about one and a half feet ( I was sitting down, leaned forward on a lazy-boy playing a game and I dropped the phone, No more then a 2 foot drop, and the second time it cracked at the top right corner. Oh and I have a Speck case that is drop tested). I hope this review will get the attention amfm and they will make this right with me, as I never received the initial screen that I sent in for. I followed there instructions as well, yet nothing. I will update the comment when and If they reach out to me. Would I recommend this product to friends or anyone for that matter, at the moment NO! Am I happy with the product I spent 40 dollars on, NO! It's all in their hands from here on out. Thank you

TLDR: Excellent, very high quality screen protector, 100% recommend, but you MUST FOLLOW INSTRUCTIONS! My biggest criticism: adhesive buildup did fall off of the applicator nozzle and into the adhesive bubbles, but that problem was easily fixed fishing it out with toothpicks. This screen protector is excellent. The tempered glass feels very similar to the s22 ultra's gorilla glass, and there's ample room on the edges to accommodate most if not all cases. You have to follow the instructions exactly! It is absolutely essential to make sure the screen applies correctly and that the application lasts. Every piece of dust must be removed, and after making sure the screen was 100% clean, the application process went very smoothly. Another thing, there may be adhesive buildup around the nozzle of the applicator that can fall off and sprinkle into the adhesive bubbles, so clean the nozzles before using them! But if it happens, use toothpicks to fish the pieces out, I did so and got excellent results despite the hiccup. Again, make sure every single piece of debris is removed from the screen, small pieces of dust that you miss will inevitably make their way in, but that's unavoidable. Another tip: add another 30-45 seconds to the last half of the curing process to ensure the adhesive cures fully. Long story short: pay attention, be meticulous with following the instructions, and you'll have an excellent experience with this screen protector. Bubbles are often due to user error/missing debris that have fallen onto the phone prior to application, and lack of adhesive durability may be due to inattention to the instructions of the curing process, so eliminate those variables as much as you can. You have to be very precise and follow the instructions exactly. For the fingerprint sensor, as expected you will need to reprogram your fingerprint for the best results, and press with a bit more pressure when unlocking your phone, but it is something you do not notice after a day or two of regular use.

I've pasted Whitestone dome glass on my wife and my s22 ultra the first day when we got the device, and is having fingerprint unlock issue since then. But because of the premium price we've paid for the glass, we thought to turn on face unlock instead and let the glass stays on the phone for at least 5-6 months before we changed to another one. However, the fingerprint unlock issue had been such an annoyance that I changed to a local brand, which many reviewed that the fingerprint unlock works, but it doesn't worked for me. I bought two pieces, one for my wife and one for myself, end up I used up both pieces, they are not any better than the Whitestone dome glass. I saw amFilm while searching in YouTube on reviewed for tempered glass installation for s22 ultra, and decided to give it a try. Amfilm didn't disappoint me, it is definitely the best ultrasonic fingerprint unlock compatible tempered glass you can find for s22 ultra! I found that the unlocking speed is no different from naked screen, I'm so happy that I bought amFilm! 😄

Fingerprint is working as mentioned.

Es excelente el producto, bien puesto pareciera que no trae nada el celular. IMPORTANTE! Poner dos botecitos de pegamento a cada cristal, de lo contrario se despegará al poco tiempo. Recomiendo ver la guía de instalación de YouTube de DOMEGLASS y no la de este producto, porque van a quedar burbujas, no presionen la zona de la huella con nada porque marcará error, ni siquiera con la pesa de metal que viene en el kit, mejor dejen que se seque bien unas 8 horas antes de presionar el sensor, ya con eso no tendrán problema alguno.

Great screen protector. Works well and although there's a lot of steps in the process, it was quite easy to apply it. One has been in use for 1+ year now and has only started cracking/peeling recently, although I want to point out this user has dropped their phone on tiles many times. The second one has been in use for 3 months now and not a single issue.