Broan SP3004 Backsplash Range Hood Wall Shield, 24 by 30-Inch, Stainless Steel

I have my oven in the corner so I ordered 2. This is a great quality stainless steel sheets. Easy to install but I would recommend to have 2 people to install. And wear some protective gloves. Also save the surroundings and it is sharp. Great fit for my oven and kitchen. Easy to clean and looks good.

Just purchased a stove that doesn’t have the part in the back that is above the burners. My current tile backsplash showed so I needed something to cover the gap. I didn’t even know these existed until now. WOW! This is perfect since it’s designed for behind a stove. Very sturdy and installed in a minute. I bought stainless steel screws for installation. Looks fantastic with my stainless steel stove. Matches beautifully and clean up is a breeze! Highly recommend this item.

Es un producto de excelente calidad lo recomiendo!

After getting new appliances, the oven we chose didn’t have any kind of backsplash. Since we’ll eventually put in tile, we decided on this for an oven backsplash. It was actually thicker than I thought it would be after reading some reviews. I’d have to agree with other reviewers that screws should have been provided. I didn’t have any issues wit bent corners or scratches. It came packaged like a painting. I did go out and buy some drywall anchors and screws (#10 or 3/16”). After peeling only the corners of the protective film, I put it where I wanted and with the help of another person, marked the screw holes. I will have to say that doing this BEFORE the installation of the stove would have made this a whole lot easier. As it was I had to pull the oven out because the backsplash extended below the back of the oven. I did run into the issue of putting it as high as I could that made drilling and then screwing in the screws a little difficult (drill clearance). Initially I left the screws a little loose so I could have a little maneuvering room while installing the screws (a two person job, unless you’re putting on some kind of adhesive). Unless you are below eye level of the microwave you don’t even see the screws. After I tightened all the screws I removed the protective film. If you’re using only adhesive, I’d make sure you’re hold it as pulling off the film made the backsplash bow. If I didn’t use wall anchors I can see it pulling out of the wall. Overall it didn’t take that long to install. I like the finished look as it matches the other appliances.

Fits a standard 30" stove opening. Works great for backless stoves with controls on the front. Easy to clean with stainless steel cleaner and saves my walls. Simple installation and was packaged well. Good value compared to other big box stores.