XMSJSIY Chassis Switch - Metal Button, PC Case LED Power Button ATX Supply On/Off for DIY Computer - 60cm, 12mm

Perfect for custom PC builds. Great value, easy to install, and has clear marking for the terminals. Pretty blue light too.

Purchased this to replace the flimsy plastic switch which was on the way out on my aging computer case. Removed the old switch and carefully/methodically expanded the hole with a step drill bit, installed the metal button and tightened the nut. The wire plugs fit perfectly on my newish motherboard—the power light plugs are separate + and - and allow flexibility in spacing. Switch looks great—stands out better than the old switch (which was black on black). System powers on and off with a gentle touch. Nice that the power LED is integrated in the button. Highly recommend this switch!!

Works great looks amazing I used this because my PC is mounted the high up away from my animals so I bought this and some extra wire to extend this up to 25 ft and run this to my button box for my sim racing setup that way I don't have to stand on top of my seat to turn on my PC looks great quality is amazing the button functions as you would expect feels very nice to press although it does not have different colors like the description shows it only lights up blue which was kind of a disappointment but super work the place and super easy to install you just plug it in where you normally would plug in the power button and reset button on your PC case and you can either extend it and mount it somewhere else like I did or replace the power button on your PC either way it's a really nice part especially for the price

Worked perfectly to replace an original on/off switch

Bought it for hubbys gaming set up, works good, made life easier than having to crawl under the desk to turn the computer on and off. Only complaint is the wire was rather short

Perfect little switch to get my improvised front bezel completed so I can finish the case mod project with a bootable system installed. I love the fact it has its own led built in and easy to install. No complaints would buy again in a heartbeat if I needed to make another custom front bezel.

While everybody's case is different. This fit perfectly in mine with a small 3D printed part I designed. It would have sit fine without it at a rubber washer instead. The cable was long enough to get from the top of my case all the way to the back corner where the power headers were. Only knock is a minor one. I feel the button has to be pressed a little bit further than I would like, for it to trigger. But that could be a feature for somebody else. It would also be nice to see this come with a washer or another nut for the exterior of the case.

Works well for "skeletonized" cases or custom cases. Positive feel and LED is very visible.

Great Replacement with a Beautiful Blue Glow The XMSJSIY Chassis Switch Host Metal Button was the perfect replacement for my PC case’s broken power button. It works flawlessly and adds a lovely blue glow to the setup. Easy to install and highly recommended for anyone needing a reliable and stylish power button replacement.

Placed button on custom case. Starts computer and lights up as advertises.

Button is good quality.

I needed a power button for my custom PC case. Being completely custom made it didn't come with one obviously, and the one I had been using for a few days was just a clicker on the end of a wire basically. This one I was able to screw into the case after drilling a hole in the side, nice and secure, and no accidental bumps turning it on when I don't want it on.

My computer shut down continuously and I thought it was the power supply unit. After diagnosing the problem, I determined it was my PC case power switch acting up. I replaced it with this switch and my computer is running again. A perfect solution and I didn't need to buy a new case!!