Lippert Components 432687 24' Radius Corner Manual Step - Triple, 7' Rise, Black

Great step with high quality, for a great price. Be sure to look at your old one,customers was welded on, took a torch and a lot of work (not burning trailer). That is not the steps fault. I been doing RV work for 55 yrs, that install is not for the faint of heart. Once installed, it was super stable. Even added the crank down support, but wasn't needed. Customer loved the ease of it rolling out and in. The old style had slots to slide on, and jammed up, DO NOT buy that style.

Excellent! Make sure to measure your RV before ordering. Mounting bracket is 27.5” wide. This was a perfect fit for my 2019 Puma 28dbfq. Arrived quickly and intact! Thank you!

¡Quedó perfecto para nuestros remolques que fabricamos!

The description isn't correct. these steps are 27 1/4 at the top of the step frame. they were a perfect fit for our Cougar ultrlight travel trailer. 3 steps bowed. However, we removed the 4 bolts holding the old steps and supported the steps with 2 concrete blocks. we then folded the steps up and pulled the assembly straight toward us and out. that part was easy. it first appeared that the new steps were slightly wider than the frame they needed to bolt to. after some minutes of frustration we realized the brackets on the trailer angled inward at the bottom and we needed to install the new steps just like we removed the old. so we raised the steps to the height they would bolt in place at and forced them between the mounting brackets. then we got a block of wood and rubber mallet and tapped on each side of the steps frame until the mounting holes began to line up. at this point i used a scratch awl (screwdriver would work as well) and put it through the first hole to pry the steps holes until it lined up. got the first bolt back on, loosely. went to each mounting hole in turn until all 4 bolts were started. Tightened everything down. be sure the sqare base of the bolts seats tightly or you bolts could shear off over time. i had to push up just a but to wiggle 2 of the bolts fully into place. They work great, feel sturdy, and my step tread covers from the old set fit perfectly. we ordered the Lippert step support to attach under the lowest step to hopefully prevent the hinge bracket from breaking, which was the problem in the original steps (trailer was purchased used and one step hinge was already damaged). that part is due to arrive in a day or two. This is definitely a 2 person job, and requires one person to get under the steps/trailer to remove, line up new steps, and tighten the bolts. Removal and installation took about 1 to 1-1/4 hrs total.

The steps are great